708550

Alecto HA-58 Manual

8
Zoom out
Zoom in
Previous page
1/10
Next page
The HA-58 is a heat detector meant to discover cases of fire in the first phase. If the temperature rises, the
HA-58 will start emitting a loud alarm tone of at least 85dB (A). It’s advisable to test the heat detector weekly by
using the test button. Attention: This heat detector only signals when the temperature rises to 55˚C or higher. It
doesn’t directly detect smoke or fire. Save this manual in a secure location, like the fuse box cabinet.
RECOMMENDED INSTALLATION LOCATIONS FOR THE HA-58:
• Install the heat detector in areas where you cannot place a smoke detector. Ensure that it is placed in a location that
ensures that, if there would be a fire nearby the detector, the escape route is still accessible.
• Use multiple detectors to increase your safety and to ensure an escape route will be available in case of fire.
• It’s advisable to place one heat detector in every location where there is no smoke detector.
• Place at least one heat detector in the kitchen and garage, where equipment present may cause fire.
• Both heat and smoke will first move upwards, to the ceiling. Then it will travel horizontally. Wall-mounting may technically
be possible but will result in slower alarm.
• When mounting the detector to the ceiling, place it at a minimum distance of 50 cm from any wall and 61 cm from any
corner. Due to natural air flow, such corners will slow or prevent detection of heat.
AVOID THE FOLLOWING LOCATION INSTALLATIONS:
• Keep away at least 3 meters from any cooking apparatus.
• Do not place in the bathroom; hot showers may cause false alarm.
• Do not place near a fan or near the exhaust of an airconditioner or heater.
• Do not place in the nook of an A-shaped ceiling.
• Do not place in rooms where the temperature can reach below 0°C or beyond 45°C.
• Do not paint the heat detector and do not cover it in any way,
INSTALLATION INFORMATION:
Install the ceiling plate on a location fitting the description above using plugs and screws. Remove the plastic foil from
the battery that is placed inside of the detector, plug it in the cable located inside the battery compartment and place it
firmly inside the compartment. Once a battery is placed, you should be able to place the detector on the ceiling plate
and rotate it easily. Test the detector first by holding the “Test”-key for 2 seconds.
The RED LED will blink every minute to show the detector is still operational.
dode
luchtruimte
60 cm minimaal
90 cm
minimaal
90 cm
minimaal
Niet in deze ruimte
In de buurt
van deze ruimte
Test
weekly
EN
9V BLOCK
9V BLOCK
9V BLOCK
… 8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto HA-58 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto HA-58 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info