458285
15
Zoom out
Zoom in
Previous page
1/20
Next page
14
15
7 POSSIBLE MESSAGES ON SCREEN
The following messages may be displayed on screen during use, either accompanied by warn-
ing tones or not:
No link:
The connection between the camera unit and the monitor unit has been lost. This may
be caused by the distance between the units being too great, by the camera unit being
switched off or by the camera unit being deactivated as a result of empty batteries.
Battery low:
The battery in the monitor unit is almost empty. The monitor unit will switch off shortly
after this warning is displayed. Connect the mains adapter straightaway to charge the bat-
tery.
Battery low at baby unit:
The batteries in the camera unit are empty. The camera unit will switch off shortly after
this warning is displayed. Replace the batteries immediately or connect the mains adapt-
er.
Temperature too high:
The temperature in the room in which the camera unit is set up is higher than the limit you
set. Take the necessary measures or set a different limit.
Temperature too low:
The temperature in the room in which the camera unit is set up is lower than the limit you
set. Take the necessary measures or set a different limit.
Eco Mode activated:
This message appears just before the system goes into sleep mode. There is now no
longer a connection between the units. The system is only reactivated when the camera
unit detects a sound.
8 TIPS AND WARNINGS
8.1 GENERAL:
Read the manual carefully and follow all the instructions.
Never place or use the camera or the monitor in a wet or damp room or environment.
Make sure that heat can be adequately dissipated; never cover the monitor unit, the
camera unit and/or the mains adapter(s) or place them immediately next to a source of
heat.
Use only the supplied mains adapter(s); connecting another type of adapter may damage
the electronic equipment.
Make sure that the adapter cables cannot be damaged and that they cannot cause
tripping or falling.
Never disassemble the monitor unit, the camera unit and/or the mains adapter(s); this
may only be done by qualified personnel.
8.2 INSTALLATION:
The mains adapter should only be connected or disconnected when it has been
unplugged from the wall socket.
Do not install the DVM-70 during a thunderstorm.
Do not touch uninsulated adapter cables unless the adapters have been disconnected
from the mains power supply.
8.3 FREE FROM INTERFERENCE:
This Digital Video Monitoring System is digitally encoded. You should therefore never
receive a signal from other equipment, nor will the signal from your camera unit appear
on, for example, your neighbours' monitor.
If the camera or monitor are located in close proximity to electromagnetic fields, this may
cause some disturbance to the signal (audio or video). In this case, try a different location
for the camera or the monitor or, if possible, remove the source of the interference.
8.4 EAVESDROPPING/INTERCEPTION:
It is virtually impossible to eavesdrop on/intercept these Digital Video Monitor signals. Not
only would one need to be in range of the video monitor, very expensive equipment would
also be required.
8.5 MAINTENANCE:
Clean the video monitor with a damp cloth only; do not use chemical cleaning products.
Before cleaning, make sure that the mains adapters are disconnected.
8.6 EXPANSION:
The DVM-70 system does not allow multiple camera units to be connected to a single
monitor unit, or for the image from a single camera unit to be displayed on multiple moni-
tor units. It is, however, possible to use multiple complete DVM-70 sets side by side at the
same time.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto DVM 70 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto DVM 70 in the language / languages: English as an attachment in your email.

The manual is 8,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Alecto DVM 70

Alecto DVM 70 User Manual - Dutch - 20 pages

Alecto DVM 70 User Manual - French - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info