668918

Alecto DVM-350 Manual

48
Zoom out
Zoom in
Previous page
1/60
Next page
48
3 INSTALLATION
3.1 BABY UNIT: (CAMERA)
The baby and parent units are not waterproof, therefore they are only
suitable for indoor use.
Power adapter:
1. Connect one of the included power adapters to the DC5.9V input on the side
of the baby unit.
2. Insert the adapter into a 230V wall socket.
Only use the supplied power adapter.
Make sure the baby cannot touch the baby unit or cable. Keep the baby unit at
least 2 meters away from the baby and bundle cables that are too long with tape
or cable ties specically for this purpose.
Table model or wall model:
You can place the baby unit on a table, cabinet or desk or you can hang it on the
wall.
In case of wall mounting:
Drill two holes next to each other in the wall separated by a distance of 4,8 cm
and insert plugs and screws. The head of the screw should stick out of the wall for
several millimeters.
Suspend the baby unit by sliding the notches in the camera support over the
screws in the wall and pushing the baby unit a little downwards.
Finally, use cable clips to neatly tuck away the adapter cable.
Tips for placement:
• For use as a baby monitor: place the baby unit at least 2 meters away from your
baby and make sure to safely tuck away the adapter cable.
• For optimal range, it is advisable to set up the baby unit as high as possible, free
from large metal surfaces.
3.2 PARENT UNIT:
The parent unit is not waterproof and therefore only suitable for indoor use.
Power supply:
The parent unit can be powered directly by the included rechargeable battery or
via the supplied power adapter. As soon as you connect the power adapter, it will
charge the battery allowing for mobile use of the parent unit.
Battery:
1. Open the battery
compartment by un-
screwing the battery
cover on the rear of
the parent unit.
2. Insert the battery.
3. Replace the battery
cover onto the pa-
rent unit and tighten
the screw.
Never forcibly insert the battery.
Only use the supplied rechargeable Li-ion battery.
Power adapter:
1. Connect the other power adapter to the DC5.9V input on the side of the parent
unit.
2. Insert the adapter into a 230V wall socket.
Only use the supplied power adapter.
Make sure nobody can trip or fall over the adapter cable. You can bundle cables
that are too long with tape or cables ties available specically for this purpose.
Charging:
The battery will be charged as soon as you connect the power adapter and insert
it into a 230V wall socket.
• For initial use, charge the battery for at least 15 hours, even if the indicator
shows a fully charged battery.
• The charging circuit for the battery is managed electronically and there is no
risk of overcharging, this allows you to leave the adapter connected at all
times.
• In case you will not use the set for a longer period of time (>2 months), please
make sure to disconnect the adapter from the wall socket and remove the
battery from the parent unit. When starting to use the set again, make sure to
properly charge the battery.
Table support:
The table support is located at the rear of the parent unit.
Unfold it to place the parent unit on a table or cabinet.
DVM-350-manual-NL-FR-D-GB-v1.0.indd 48 22-3-2016 15:01:55
… 48 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto DVM-350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto DVM-350 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 12,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info