5.2 INSTALLATION
• Only connect the power wire or disconnect the adapter is removed from
the wall socket.
• Never install the camera during thunder storms.
• Never touch non-insulated wires unless the plug or adapter is unplugged.
5.3 MAINTENANCE
• Only clean the camera with a moist cloth; never use chemical cleaners.
Before any cleaning, you must disconnect the adapters.
5.4 ERROR
• In case the camera no longer shows any images, please check the
following:
- the camera is connected
- the correct UID code is used
- the correct password is used
- restart the camera by briefly interrupting its power supply
- press and hold the reset button for at least 10 seconds to reset the
camera. The camera will now reboot. Repeat the entire setup and
actions from the beginning, because all settings will be reset to the
default factory settings
- restart your smartphone or tablet.
• When it becomes dark, the camera will switch to the night mode and
turn on the infra-red lights. In certain environmental lighting conditions,
the screen might start flashing. You can resolve this by increasing or
decreasing the environmental light. When the IR LEDs are activated, the
screen will be black/white.
• If you still see no images, please contact the service department of
Alecto via www.alecto.nl.
5.5 IMAGE DELAY
• Because of coding and decoding of the images, there will be a slight
delay in the signal. The image quality also depends on changes in the
bandwidth via internet. You may set a lower resolution.
• The camera may restart after changing certain settings. In this case it’ll
take some time (maximum 2 minutes) before the images return.
