4. DECLARA
The declaration of conformity is available on the website
www
5. AUTHORIZED USE
The DBX-30 works on a frequency of 1800MHz. Use of
this equipment is allowed in all countries of the EU.
6. ENVIRONMENT (discarding)
At the end of the product’s life span, it must not be dis-
posed of as normal domestic waste. Y
collection point for the recycling of electric and electronic
equipment.
Never throw away exhausted batteries, but bring them to
your local depot for small chemical waste.
7. TECHNICAL SPECIFICA
Power adaptor: model: S003GV0600050
in: 100-240V
out: 6V DC 500mA
Freq 1880MHz - 1900MHz
10 channels, auto select
Operating temperature: 0 ~ 40°C
Storage temperature: -20 ~ 70°C
Range: up to 50m indoors
up to 300m outdoors
Batteries: 2x AAA
or 2x
with side input for charging!
Parent unit lifespan on battery: max. 10 hours
Parent unit battery recharge time: max. 8 hours
4. replace the battery cover and turn it tot the right (CLOSE)
to lock it
5. insert the small plug of the power adaptor into the DC
6V input of the parent unit and insert the adaptor into a
230V
6. now please charge the parent unit continuously for
15 hours to properly charge the battery pack
A
Insert the batteries into the parent unit rst and then con-
nect the power adaptor
9.2 BABY
The baby-unit is powered by the supplied power adaptor
Connect the power adaptor with the 6V DC connection of the
parent unit and plug the power adaptor in a 230 V
socket.
9.3
• Do NOT
maintain a minimal distance of 1-2 meters between the
baby and the baby unit.
• MAKE SURE THE BABY CANNOT TOUCH THE
ADAPTOR CABLE.
• Do not expose the baby-unit or parent-unit to direct sunlight
or humid areas. This baby intercom is not water-proof,
penetrating moisture can cause damage to the electronics.
10 USE
Don’t forget that this baby intercom is merely an extra piece
of mind. The device can never replace the physical and
monitoring presence of a parent or babysitter
10.1
SWITCHING ON/OFF
Switching on the parent unit:
1. press and hold the power unit for at least 2 seconds to
switch on the parent unit
2. the power indicator starts flashing and the parent unit will
establish a connection with the baby unit
Enable baby unit:
1. press and hold the power unit for at least 2 seconds to
switch on the parent unit
2. the power indicator starts flashing and the parent unit will
establish a connection with the baby unit
Connection OK:
as soon as the parent unit and baby unit have ‘found’
other
remain lit.
Switching off the parent unit and baby unit:
press and hold the power push-button on the parent or baby
unit for 2 seconds to switch off this unit
10.2 LISTENING:
As soon as the baby unit detects any sound, this sound will be
transmitted to the parent unit.
Reception volume:
Y+
and - on the parent unit.
Upon reaching the maximum or minimum volume, an extra
beep tone will sound when you press the + or - button.
Optical sound notification:
the sound indicators on the parent unit will illuminate accord-
ing to the rhythm of the bay crying; this provides you with an
indication of the sounds in the baby room even when you’re
turned off the volume
10.3 CALL T
Y
or to look for the parent unit in case you’ve misplaced it. Keep in
mind that the parent unit must be switched on in order to emit the
call tones.
1. briefly press the button on the baby unit
2. the parent unit will emit a series of 2 beep tones
3. this beep tone will stop after 2 minutes or you can press a
random button to stop the beep tones earlier
these beep tones can also be heard when the volume at the
parent unit is set to 0 (no sound)
10.4 NIGHT LIGHT
The power indicator of the baby unit also acts as a night light.
Keep in mind that you cannot switch off this light without also
switching off the baby unit.
10.5 VOX (voice operated switch)
With the VOX switch on the parent unit set to OFF
unit will transmit all sounds of the baby to the parent unit, also
when the baby is sleeping quietly
With the VOX switch set to ON, the baby unit will only transmit
sounds when the baby is crying.
The sound level at which the baby unit switches on in the VOX
ON mode is fixed and cannot be adjusted.
1 OTHER FUNCTIONS
1
When the VOX switch on the parent unit is set to ON, the
baby unit will stop transmitting when the baby is sleeping
quietly
However
between the baby unit and parent unit.
When the VOX switch is set to OFF
continuously which means the ECO MODE is not available
with VOX OFF
1
Parent unit:
As soon as and for as long as the parent unit and baby unit
are in contact with each other
tinuously on the parent unit will remain lit.
As soon as the parent unit gets out of range from the baby
unit (or the baby unit is switched off or malfunctions), this
indicator will start flashing while the unit emits a beep tone
every second.
As soon as the cause for the out-of-range notification has
been resolved, the connection indicator will become green
continuously and the beep tones will no longer be emitted.
Also when the units are first switched on, the connection indi-
cator will start flashing at first. The parent unit is now ‘search-
ing’
indicator will become green.
Baby-unit:
When the connection between the parent unit and baby unit
is lost, the power indicator at the baby unit will start flashing.
However
1
At least an hour before the parent unit switches off because of
empty batteries, the red power indicator will illuminate and a
beep tone will be emitted every 30 seconds. Please connect
the adaptor to recharge the batteries or insert full batteries.
12 GENERAL
12.1 GENERAL:
Before every use, always check whether the baby intercom
is functioning correctly
intercom’s range and connection, it’
its connection by ear while in use.
Only use the baby intercom as an additional peace of mind, it
can never serve as a replacement for an adult or human and
baby sitter
The DBX-30 may not be used for anything else besides
detecting sounds within your own private surroundings; any
person located in the room that’s being listened to must be
informed about the baby intercom being used.
Y
intercom. The system can be freely applied in any domestic
situation. However
cannot always be guaranteed.
In case the units is not being used, please always turn the
device off using the power button.
TO
TO MAKE SURE
ADAPTOR CABLE
12.2 MAINTENANCE:
Only clean the baby monitor with a moist cloth; never use
chemical cleaners. Before any cleaning, you must disconnect
the adapters. Before cleaning, any connected power adaptors
must be disconnected.
12.3 USING MUL
The technology of the DBX-30 allows for the simultaneous
and strings-free use of multiple complete baby intercom sets
(baby-unit and parent-unit) next to each other
multiple baby rooms at the same time; each parent/baby-unit
combination is provided with its own unique code, making
it impossible to receive DBX-99 signals from other baby
intercoms or for other baby intercoms to receive the sound
from your baby
It is not possible to expand your DBX-30 with individual baby-
units or parent-units.
12.4 POWER SUPPL
Adaptors:
When using adaptors, only use the supplied adaptors.
Connecting power adaptors other than the supplied adaptors
can cause damage to the electronics of the DBX-30 intercom.
Batteries:
Y
keep in mind that rechargeable batteries are charged at the
SIDE of the batteries. This means not all rechargeable batter-
ies can be used. When the supplied batteries are exhausted,
please contact the
rechargeable batteries with a side connection.
Order number of this battery type: “DBX-30.00”. We recom-
mend you to always replace both batteries at the same time,
even when only one battery is exhausted.
12.5 RANGE:
This baby intercom has a range of 300 meters in an open
field and up to 50 meters indoors; this range depends on local
conditions (concrete walls, other baby intercoms, wireless
phones, etc.).
12.6 P
With fully charged batteries with a capacity
the parent unit more than 10 hours. This time depends on
the use (the setting of the volume level, the condition of the
rechargeable batteries, etc.).
Keep in mind that the parent unit still uses a small amount
of power when switched off.
to leave the parent unit connected to the power adaptor at
all times, even when you’re not using the baby monitor
ensures the battery pack is fully charged at any time you need
to make mobile use of the baby monitor
The charging time of empty batteries is approximately 8 hours.
13 W
For the
of purchase. During this period, we guarantee the free repair of defects
caused by material and workmanship errors.
final assessment of the importer
HOT
manual. If the manual provides no definite answer
the supplier of this baby video monitor or contact customer service of
Alecto on telephone number 0 73 641
5666 (Belgium) or via internet www
THE W
use, incorrect connections, leaking and/or incorrectly installed
batteries, use of unoriginal parts or accessories, negligence and
in case of defects caused by moisture, fire, flooding, lightning and
natural disasters. In case of unauthorised modifications and/or repairs
performed by third parties. In case of incorrect transportation of
the device without adequate packaging and when the device is not
accompanied by this warranty card and proof of purchase.
The warranty does not cover connecting cables, plugs and batteries.
All further liability
is excluded.
DBX-30 Baby monitor
User
1 INTRODUCTION
The DBX-30 is a baby alarm / monitor that allows you to
wirelessly listen to the sounds being picked up by the mi-
crophone in the transmitting unit. This device is commonly
used as a baby monitor for babies and small children or
as a sound monitor for elderly people.
2. INTENDED USE
The DBX-30 is a sound alarm / detector for household
use only
physical presence of parents, baby sitters or caregivers.
3. ECO MODE
The DBX-30 baby monitor is equipped with an ECO
MODE in which the transmitter is turned off automatically
when your baby is sleeping quietly and only switches on
when this is necessary
see also chapter 1
1. possibility to carry the parent unit on e.g. your belt using a
lanyard
2. power button
3. power adaptor connection
4. built-in speaker
5. power indicator & status indicator & sound indicators
• ashing green indicator when the parent unit is search-
ing for the baby unit
• green indicator remains lit when the parent unit is con
nected to the baby unit
• ashing red indicator when the batteries are charging
• red indicator remains lit when the batteries are almost
empty
• to the left and right and in the upper part, red indicators
will illuminate when the baby is crying to notify you in
case you’ve set the volume to OFF
6. VOX function switch
7. volume increase/decrease buttons
8. battery compartments (rear of parent unit)
9. power indicator
• ashing green indicator when the baby unit is searching
for the parent unit
• green indicator remains lit when the baby unit is con
nected to the parent unit
10.
1 built-in microphone
12.
13.
9 INST
9.1
1. The parent unit is powered by the 2 included rechargeable
batteries. These batteries are charged through the
included power adaptor
2. turn the battery cover at the rear of the parent unit to the
left (OPEN) and remove it.
3. insert the rechargeable batteries according to the
markings inside the battery compartment, please pay
attention to the polarity (+ and -).
8 OVERVIEWS
Parent unit:
Baby-unit:
15
2
3
6
47
8
9
10
12
11
13
v1.1
