626264
11
Zoom out
Zoom in
Previous page
1/16
Next page
GB
CONNECTION TO HOT WATER 4.
HEATER
(Applies only if a water heater 2959 is tted)
In order for the water heater to work, it must be con-
nected to the fresh water system. From the heater, the
hot water hose should run to the shower, thermostat
mixer, sink, etc. On the water heater, connections
1/4"R should be used. P.T.F.E. tape or similar should
be used a thread of connections to avoid leakage.
The fresh water connections are located on the rear of
the heater. Incoming water at the bottom and outgoing
water at the top. So that the fresh water can be easily
drained off when the heater is not in use, a drain cock
should be tted to the incoming connection and an air
screw on the outgoing connection.
Fig 15
Air screwA.
Hot waterB.
Water heaterC.
Cold waterD.
Drain cockE.
INSTALLATION INSPECTION5.
The LP gas system:
After installation or service, always test the LP gas
installation under pressure following currently valid
regulations.
If a leak is present, nd the leak using leak detection
spray or soapy water. Note: open ames must not
be used during leak localisation.
Check that the reduction valve is at the right
pressure.
We recommend the mounting of an Alde LP gas leak-
age tester in order to further increase safety. The tester
is mounted closest to the reducing valve and enables
you to test that the system does not leak by simply
pushing a button.
The heating system:
The heating system should be tested for leaks when
the complete system is visible, that is, before any
ttings are mounted. Two methods are possible:
either test pressurisation at 0.75 - 1.0 bar for 15 min
utes, followed by reduction of the pressure to a maxi
mum of 0.05 bar; or by lling the system with liquid
and checking by inspection. No leakage of liquid can
be accepted.
Check that all hose clips are tted and correctly
placed.
Other points:
Check that the drainage tubes and the bleed tube on
the expansion tank are not blocked, and check that
the drainage tap on the water heater (if mounted) is
not blocked.
Check that the circulation pump rotates in the correct
direction (anticlockwise) at the rubber connection.
Check that the chimney and the chimney pipe are
correctly placed and securely attached, and check
that the input tube on the Comfort 2928 is mounted
on both chimney and boiler.
Check that air can pass freely through the ventilation
drum.
11
11


Need help? Post your question in this forum.

Forumrules
1

Forum

alde-comfort-2928

Reset search

  • Where can I get an Alde control house and lid in EUROPE for a 2923/2928? Submitted on 29-8-2021 at 17:16

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alde Comfort 2928 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alde Comfort 2928 in the language / languages: English, German, Swedish as an attachment in your email.

The manual is 1,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Alde Comfort 2928

Alde Comfort 2928 User Manual - English, German, Dutch, French, Swedish, Finnish - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info