567466
7
Zoom out
Zoom in
Previous page
1/16
Next page
7
Attach the red wire to a part of the vehicle electrical system which is interconnected
to the ignition.
Connect the black wire to the negative pole on the battery or the vehicle body.
Note for all connecting methods:
For EMC reasons, the cable used to connect to the power supply should be no longer than 3
metres.
If you wish to operate your set at home from the mains supply then please only use a
stabilised power supply with at least 3 amps permanent current capacity. Under no
circumstances should you use a car battery charger, as these are not stabilised and during
open circuit reach such high voltage levels that your radio set could be destroyed.
Never repair a blown fuse with silver paper or with aluminium foil! If the fuses keep blowing,
then please give your radio set to your servicing dealer to be repaired or hand it in to an
authorized service station.
The maximum allowed voltage variation for this radio is from 10.8 volts up to 15.6 volts.
Never exceed the upper voltage limit under no circumstances!
Antenna Connection
Connect your CB antenna to the antenna socket on the rear side of your ALBRECHT AE
6199. Most CB antennas must be tuned to best radiation during installation to give highest
effective communication range. CB specialists do that job with a standing wave (SWR)
meter to check and adjust the aerial. Tune the antenna to the best standing wave ratio
(SWR) on a medium channel number e.g. using Channel 1 in 80/40 mode (26.965 MHz) or
Channel 20 (27.205 MHz) in all other modes. Truckers should prefer CH 9 for optimum
alignment.
On this channel you should obtain a SWR of approx. 1.5 or less (the best possible value is
1.0). If the SWR deteriorates on the highest (Channel 40) and lowest (Channel 41) channels
up to a value of 2.5, then your aerial is still acceptable. SWR above 3 is too bad for good
communication range. A bad SWR may also indicate that there is perhaps an installation
error or missing ground. Problems may be caused through missing ground, especially in
boats and motor homes with fiber glass body. For these cases, Albrecht offers a special
connecting cable with matching box as “artificial ground” (AKM 27), or ground less antennas
like GL 27.
Some antennas, like “Gamma II are broadbanded and do not need any retuning
during installations.
Even if your AE 6199 is a heavy duty transceiver with a high-level output stage which
can even withstand mismatching of SWR=3, you should still never transmit without
an antenna!
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Albrecht AE 6199 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Albrecht AE 6199 in the language / languages: English as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Albrecht AE 6199

Albrecht AE 6199 User Manual - German - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info