592614

Al-ko Classic 5.14 SP-S Manual

28
Zoom out
Zoom in
Previous page
1/400
Next page
GB
Translation of the original operating instructions
28
Petrol lawn mower
Do not start the unit if the discharge chute is not
covered by one of the following parts:
Grass catcher
%DIÀHSODWH
Mulch kit
Operate the starter switch with particular care ac-
cording to the manufacturer instructions
0DNHVXUH\RXUIHHWDUHDWDVXI¿FLHQWGLVWDQFH
away from the cutter unit.
Start the unit in low grass
Position indicators on the unit:
Choke*
Start Run Stop
Speed remote
control*
Start Stop
Speed remote
control, with
choke*
Vario gearbox*
Fast Slow
Blade clutch*
On Off
*depending on version
Manual starting
Without speed remote control, with choke
Choke
Start Run Stop
1. Set choke to position 1 ( 13/1).
2. Pull the safety bar to the upper bar and hold (
17) – safety bar does not engage.
3. Pull the starter cord quickly and allow it to slowly
coil up again (
18).
4. After the motor has warmed up (approx. 15-20
seconds), set the choke position 2 (
13/2).
Starting the motor
Danger - risk of poisoning!
Never run the motor in enclosed spaces.
Danger - risk of injury!
Do not tip the unit during the starting procedure.
ƒ Only start the motor with mounted blade (the
blade serves as centrifugal mass)
ƒ When starting the warmed motor, do NOT use
the (HONDA) choke or primer button
ƒ Do not modify the control settings on the motor
Inserting the side discharge
1. Remove the grass catcher and insert the mulch kit.
2. Fold open the cover for the side discharge and hold
¿UPO\(
11/1).
3. Insert the side discharge chute (
11/2).
4. Slowly close the cover.
The cover secures the side discharge channel from
falling out.
Removing the side discharge
1. Fold open the cover for the side discharge and hold
¿UPO\(
11/1).
2. Remove the side discharge and close the cover (
11/2).
Working height adjustment (option)
The working height can be adjusted to two different
heights, if needed.
1. Screw off both handle screws on the handle bar
¿WWLQJ
2. Pull out the threaded bolts and adjust to the desired
position by inserting into one of the two square
holes on the holders and through the bars (
12).
Make sure that the same hole is used on each of
the holders!
3. Tighten the holders with the lower bar again using
the handle screws.
… 28 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Al-ko Classic 5.14 SP-S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Al-ko Classic 5.14 SP-S in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 10,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Al-ko Classic 5.14 SP-S

Al-ko Classic 5.14 SP-S Instructions - English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info