629515
4
Zoom out
Zoom in
Previous page
1/5
Next page
Using a 17mm spanner, slacken locking nut on push rod away
from Bowden cable abutment as directed above.
Unscrew push rod from brake rod and slide it from the guide
tube. Remove the locking nut from push rod using two 17mm
spanners.
TROUBLESHOOTING
Should you experience a fault with ATC, the LED light
on the fairing will change colour. Therefore, refer to the
table on page 4 and follow the instructions.
If no illumination of the LED is evident, refer to system
requirements on page 3 and check towbar wiring for
permanent supply.
In the unlikely event that you receive a red flashing LED
light and disconnecting and re-connecting the power
does not alleviate the problem, check the push rod
position as detailed below.
Locate ATC on the axle and check the position of the
push rod.
If no red line is visible, ATC is not active, and can be
driven. However, we recommend that you contact AL-KO
at the earliest convenience.
If the red line is visible on the push rod, as shown on
the left, the caravan should not be moved.
The push rod needs to be removed to deactivate ATC.
Using two 17mm spanners, the removal process is as
shown opposite.
MAINTENANCE AND WARRANTY
ATC is maintenance free and requires no servicing. In
case of any damage to ATC, please contact AL-KO. ATC
is a sealed unit and any evidence of removal of ATC or
the component parts including outer casing and fixings
will immediately invalidate any product warranty.
ATC is covered by a 12 month warranty where it is
retrofitted to a caravan. If ATC is fitted as standard by
the vehicle manufacturer then ATC is covered for the
same duration of the vehicle warranty or whichever is
longer.
If ATC is subject to a call out under warranty and found
to comply with the relevant specification or standard,
then the cost of any testing or callout charges will be
borne by the customer. We reserve the right to request
credit card details to cover payment in advance.
REMOVAL OF PUSH ROD:
5 6
Re-apply the removed locking nut onto brake rod thread to
secure ball nut as shown above. ATC is now deactivated.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Al-ko ATC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Al-ko ATC in the language / languages: English as an attachment in your email.

The manual is 0,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info