594311
14
Zoom out
Zoom in
Previous page
1/166
Next page
14
Original instructions for use
Keep your body and clothing away from the blade
system.
People who are not familiar with the trimmer should
practice handling it while the motor is turned off.
Wear appropriate working clothes.
Make sure you can stand securely when working.
Always operate the machine with two hands.
Keep other people out of the danger area.
Do not leave the machine unsupervised.
When mowing on a slope, always stand below the
cutting device.
When working on a slope:
Never work on a smooth and slippery slope.
Always ensure that you are standing securely.
Always mow across the slope, never down or up.
Do not work on slopes with a more than 10°
gradient!
Pay particular attention when turning!
After contact with a foreign object:
Switch off the motor.
Check the machine for damage.
Do not operate the machine if you are under the
inuence of alcohol, drugs or medication.
Comply with the accident prevention regulations.
Electrical safety
Caution!
Danger of touching live parts!
Immediately disconnect the plug from the mains if
the extension cable has been damaged or cut! We
recommend connecting via an RCCB with a rated
residual current < 30 mA.
The domestic mains voltage must match the
information relating to mains voltage in the technical
data; do not use any other supply voltage.
Only use extension cables that are intended for
outdoor use – minimum cross section 1.5 mm
2
. Always
reel in cable drums fully.
Do not use damaged or brittle extension cables.
Check the condition of your extension cable before
each use.
Secure the extension cable in the cable strain relief.
Do not get the machine wet or expose it to moisture.
Keep children away from machines connected to the
mains.
Assembly
Important
The machine is not allowed to be operated unless
it has been fully assembled.
Installing the guard plate (Fig. 2)
The knife integrated in the guard plate
automatically cuts the line to the optimum length.
1. Lay lower handlebar part (2) on the ground.
2. Push guard hood (1) over the end of the handlebar
so the holes of the guard plate and the handlebar
attachment overlap.
3. Screw the guard plate rmly onto the handlebar using
cap screw (3) and hex nut (4) to be inserted on the
guard plate.
Installing the auxiliary hand grip (Fig. 3)
1. Pull grip bar (1) of the auxiliary hand grip apart
slightly.
2. Push auxiliary hand grip onto holder (3).
3. Engage the auxiliary hand grip in the splines.
4. Use hex screw (2) and clamp handle (4) to secure in
the required position.
Installing the handlebar (Fig. 4)
1. Push lower handlebar part (1) into the holder on the
upper handlebar part until lever (2) engages.
2. Use tensioning screw (3) to secure the handlebar
connection.
Installing the spool (Fig. 5)
1. Push spool head (1) with inserted spool onto the drive
shaft of the lower handlebar.
2. Screw in fastening screw (2) anticlockwise.
3. Hold the spool head rmly and tighten with the
spanner (3).
Start-up
IMPORTANT!
Always perform a visual check prior to start-up.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Al-ko AL-KO BC 1000 E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Al-ko AL-KO BC 1000 E in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info