601531
19
Zoom out
Zoom in
Previous page
1/188
Next page
Assembly
440109_a 19
CAUTION!
Do not insert the battery until the appli-
ance has been completely assembled.
Mounting hand guard and grip
1. Fasten handguard (2-1) with enclosed screws
(2-2) on the housing.
2. Pull apart easily front hand grip (3-1) and put
it on the housing. The interlocking (3-2) must
snap.
3. Pass clamping bolt through hand grip and
housing and fasten it (3-3).
STARTUP
CAUTION!
Always perform a visual check prior to
start-up.
CAUTION!
Do not use damaged batteries. Danger
of fire!
CAUTION!
Danger of explosion and fire!
The charger heats up during charging.
Do not place it on a flammable surface or
in a flammable environment.
Charging the battery
ADVICE
The battery is supplied partially charged!
Fully charge the battery before the first
use.
The battery can be charged in any
charge level. Interrupting charging does
not damage the battery.
ADVICE
The battery is protected against exces-
sive charging by a supply voltage control
function, which means it can be left con-
nected to the mains for some time.
1. Connect the charger (1-5) to the mains wi-
thout the battery (1-4). The LED on the mains
adapter lights up green.
2. Connect the battery to the charger. The LED
on the mains adapter lights up red. Charging
starts.
ADVICE
The temperature range for charging
should be between 5 and +45 °C.
The charging time for a full charge is
max. 200 minutes. If the operating time
of the battery is significantly shorter in
spite of full charging, this indicates the
battery service life has expired and it
must be replaced by a new, genuine bat-
tery.
3. The charging process has finished when the
LED on the mains adapter lights up green -
the battery is fully charged.
4. Disconnect the charger from the mains.
5. Remove the battery from the charger.
Inserting the battery
1. Press the locking catch.
2. Push the battery along the guide until the con-
tact socket on the battery is firmly located on
the contact plug of the appliance.
OPERATION
Starting the hedge trimmer
1. Keep proper footing and balance.
2. Grip the front hand grip with one hand, then
grip the rear hand grip with the other hand.
3. Press the switches on both hand grips (5); the
machine will start:
4. Keep both switches pressed while working.
5. The hedge trimmer will stop immediately if
one of the switches is released.
INFORMATION ON WORKING
The built-in spirit level (1-5, 5) facilitates cut-
ting along a straight line
Always cut both sides of the hedge first, be-
fore cutting the top. This will prevent cut ma-
terial from falling into areas that have not yet
been cut (9)
Hedges should always be cut in a trape-
zoid shape. This prevents the lower branches
from becoming bare
Make sure the motor is stopped before you
remove any cuttings.
When leaving unattended / transporting the
machine:
Switch the machine off
Push on the safety cover
Remove the battery
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Al-ko Akku-Heckenschere HT 18V Li at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Al-ko Akku-Heckenschere HT 18V Li in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info