520607

AKO HC 210 TSD Manual

4
Zoom out
Zoom in
Previous page
1/16
Next page
4
1. Important Information
Keep these instructions in a safe place and pass them on to
possible future owners.
• Use device for room heating within enclosed rooms only.
• Repairs and corrective measures may only be carried out by
skilled technicians.
• Disconnect the power supply in the event of fault (pull out
the device plug or switch off the fuse).
• Do not use this device next to the bathtub, shower,
washbasin or swimming pool.
• The device carries the symbol shown on the right,
which indicates that the heating device must under
no circumstances be covered with any objects.
• Children or persons who are not capable of operating the
device safely must not operate the heating device. Ensure
that children do not play with the device.
• Caution! Potential dangers can arise when the device
switches on automatically, e.g. devices which have been
covered or blocked by objects since they were last used can
cause fire.
• Do not operate the heating device in rooms where highly
flammable substances are used (e.g. solvents, etc.).
• Do not lay the connecting cable across the device.
2. Technical Device Description
Heat output: 2000 W Degree of protection: IP21
Connection voltage: 1/N~, 230-240 V, 50 Hz
Dimensions in mm: (W x H x D) 235 x 569 x 235
3. Installation
Do not cover the heating device with any objects; fire hazard!
The fan heater may only be used as shown, i.e. on a horizontal,
even surface. Using it on deep pile carpets is not permitted.
Please use caution when installing it in front of flammable
objects. The power plug must always be accessible.
Observe the minimum clearances.
4. Electrical Connection
The voltage information on the type plate must match the local
mains voltage.
The indicator lamp is lit, when the device is plugged in.
When the power cord of this device is damaged, it must be
replaced by a qualified person, in order to avoid risks.
5. Operation
Start the heater by pressing the on/off button.
5.1 Setting the operating mode
Pressing the "Operating mode" button allows you to choose
between the following functions.
5.1.1 Automatic mode
The device heats at the high heating level. You can set the
temperature you want using the +/- buttons. The device
switches off automatically when the set temperature is reached
and back on again when the temperature falls below the value
set.
5.1.2 Fan mode
Fan on without heating.
5.1.3 Heating mode - low heating level
The device heats at 50% of the maximum heat output. The
temperature cannot be set.
5.1.4 Heating mode - high heating level
The device heats at the maximum heat output. The
temperature cannot be set. All of the valid settings made using
the buttons are confirmed by an acoustic signal. The settings
made last are saved as long as the device is plugged in.
5.2 Rotating mode
Pressing the "OSC" button switches rotating mode on and off.
The heater rotates by a total of 90° to the left an d right in fan or
heating mode.
5.3 Timer
Pressing the "Timer" (remaining time) button limits the heater's
operating time. If, for instance, "1HR" is set, the device
switches off after one hour has elapsed. It is only possible to
set full hours up to a maximum of 8 hours of remaining time.
Warning!
Depending on the size of the room, heat requirement and
thermostat setting, rooms may overheat if the heating is not
controlled. This can be dangerous for people who are not able
to leave the room as it gets too hot.
Operating Instructions
Fan Heater HC 210 TSD
GB
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AKO HC 210 TSD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AKO HC 210 TSD in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info