Manual Aiwa TS-990CD (page 7 of 57) (English, German, French, Italian, Portuguese, Spanish)

793965

Zoom out

Zoom in

1/57

en 12

TIME SETTINGS FM RADIO

SETTING THE CURRENT TIME

1. While the speaker is in standby mode, press

the TIME/PROG. button. The hour digits

on the display will blink.

2. Press the or buttons to select the

“24H” or “12H” format and press to

conﬁrm the selection.

3. Press the or buttons to set the hour

and press to conﬁrm. The minutes

digits on the display will blink.

4. Press or to set the minutes, press

to conﬁrm.

SETTING THE ALARM

This unit may be used as an alarm clock. The

CD/USB/card or FM radio are activated to

play at a preset time.

1. Press to switch the unit to standby mode.

2. Make sure that you have set the clock

correctly.

3. Press the ALARM button in shutdown state.

4. Press or repeatedly to set the hour.

Press to conﬁrm.

5. Press or to set the minutes. Press

to conﬁrm.

6. Press or to select the alarm volume

from 0 to 30. Press to conﬁrm.

7. Press or to scroll through OFF-CD-

USB-CARD-RADIO status. Press to

save the alarm.

8. The display will show the current time.

SNOOZE PERIOD

1. Whenever the alarm rings, it can be

temporarily suspended for a short period

of approximately 9 minutes, by pressing

once the ZZZ key on the remote control,

or the button on the top panel.

2. The alarm will then automatically begin to

ring again after approximately 9 minutes.

3. To deactivate the snooze, press and

release the button once.

You can store up to 30 of your favourite stations

in the tuner memory for easy recall at any time.

AUTO SCAN

1. Press the SOURCE key to select “RAD”

radio mode.

2. Long press the button, and your

speaker will scan and stop automatically

when it finds a station with sufficient

signal strength.

3. After a few seconds, the display will update.

The display will show the station frequency.

4. Press MEM+ or MEM- on the remote control,

or brieﬂy press / on the top panel to

view and listen to the preset radio stations.

5. To find other stations, press and hold for

2 seconds the button.

6. To scan the FM band in the oposite direction

(high frequencies to low frequencies),

press the button and hold for 2 seconds.

MANUAL SCAN

1. Press the SOURCE key to select “RAD”

radio mode.

2. Press or to tune to a station. Each

press on the tuning button will change

the frequency up or down by 100 kHz.

3. Once you ﬁnd a station you want to save,

press and hold the MEM button on the

remote control or TIME/PROG on the top

panel. “S 01” will be shown on the display;

press MEM+ or MEM- until the desired

memory position number appears on the

display. Press the MEM or TIME/PROG again

to conﬁrm and save the current station.

4. Brieﬂy press MEM on the remote control;

or press TIME/PROG on the top panel,

“S 01” will be shown on the display; then

press MEM+ or MEM-, in order to view or

listen to the stored radio stations.

CREATING A CD PLAYLIST

The Program feature may be used to program

up to 33 tracks for CD and 99 tracks for

CD-MP3 to play in a selected order.

1. While in stop mode only (CD is not playing),

press and hold TIME/PROG on the top

panel of the unit, or the PRG button on the

remote control for 2 seconds, and the LED

display will show the wording “P 01” and

“T 01” starts to flash.

You can play in your tower speaker your

audio CD/ CD-R/ CD-RW/ MP3.

1. Press the button to turn on the unit.

2. Press the SOURCE button repeatedly to

select the CD function.

3. Press the button to open the disc tray.

4. Insert a CD with the printing side facing

up and close gently the disc tray by

pressing again. The disc will start the

playback automatically.

5. To temporarily stop playback, press the

button, and to resume playback, press

it again.

6. Press the button to stop playback.

SEARCHING FOR A SECTION WITHIN A TRACK

During playback, press and hold or

buttons to ﬁnd a speciﬁc passage within

the track and release it at the point you

want to listen to.

SELECT ANOTHER TRACK OR FILE

Press or buttons to skip to a dierent

track number.

Press once to hear the beginning of

the current track, and press it two or more

times to hear the previous track.

LISTENING TO YOUR TRACKS REPEATEDLY

Press the ALARM/REPEAT on the top panel

of the unit, or REP on the remote control

repeatedly to activate the repeat function

in following manner:

1. ONE (repeat the current track)

2. ALL (repeat all the available tracks)

3. OFF (cancel the repeat function)

ABOUT MP3 DISC COMPATIBILITY

With this unit is limited as follows:

Sampling Frequency: 32-48 (MP3)

Bit rate: 32-320kbps (MP3)

Do not use special letters such as:

/ :*?< > etc

Even if the total number of files on

the disc is more than 1000, it will only

show up to 999.

BASIC OPERATION CD / MP3

2. Press the and buttons to allocate the

desired track.

3. Press TIME/PROG or PRG to select and

store the track into the memory.

4. Repeat steps 2 and 3 to select up to 33/99

tracks.

5. To play the selected tracks (in the program

mode), press the button.

6. Press the button to hear the previous

programmed track or press the button

to hear the next programmed track.

7. To clear the programmed tracks from the

memory press the button twice.

Note:

• Because MP3 discs have a large capacity,

disc access times are a little longer.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Aiwa TS-990CD in the language / languages: English, German, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 3.35 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Aiwa TS-990CD Manual

Product: