Manual Aiwa NSX-V8000 (page 3 of 76) (English, French, Spanish)

496600

Zoom out

Zoom in

1/76

PRECAUTIONS

Read the Operating Instructions carefully and completely before

operating the unit. Be sure to keep the Operating Instructions

for future reference, All warnings and cautions in the Operating

Instructions and on the unit should be strictly followed, as well

as the safety suggestions below.

Installation

Water and moisture — Do not use this unit near water, such

as near a bathtub, washbowl, swimming pool, or the like.

Heat — Do not use this unit near sources of heat, including

heating vents, stoves, or other appliances that generate heat.

It also should not be placed in temperatures less than 5°C

(41”F) or greater than 35°C (95°F).

Mounting surface — Place the unit on a flat, even surface.

Ventilation — The unit should be situated with adequate

space around it so that proper heat ventilation is assured.

Allow 10 cm (4 in.) clearance from the rear and the top of the

unit, and 5 cm (2 in.) from the each side.

- Do not place the unit on a bed, rug, or similar surface that

may block the ventilation openings.

- Do not install the unit in a bookcase, cabinet, or airtight rack

where ventilation may be impeded.

Objects and liquid entry —Take care that objects or liquids

do not get inside the unit through the ventilation openings.

Carts and stands — When

placed or mounted on a stand

or catt, the unit should be moved

with care.

Quick stops, excessive force,

and uneven surfaces may cause

the unit orcartto overturn or fall,

Condensation — Moisture may form on the CD pickup lens

when:

- The unit is moved from a cold spot to a warm spot

- The heating system has just been turned on

- The unit is used in a very humid room

- The unit is cooled by an air conditioner

When this unit has condensation inside, it may not function

normally, Should this occur, leave the unit for a few hours,

then try to operate again.

Wall or ceiling mounting —The unit should not be mounted

on a wall or ceiling, unless specified in the Operating

Instructions.

Electric Power

1 Power eources — Connect this unit only to power sources

specified in the Operating Instructions, and as marked on the

unit.

2 Polarization — As a safety feature, some units are equipped

with polarized AC power plugs which can only be inserted

one way into a power outlet. If it is difficult or impossible to

insert the AC power plug into an outlet, turn the plug over and

try again. If it still does not easily insert into the outlet, please

call a qualified service technician to service or replace the

outlet. To avoid defeating the safety feature of the polarized

plug, do not force it into a power outlet.

AC power cord

- When disconnecting the AC power cord, pull it out by the

AC power plug. Do not pull the cord itself.

- Never handle the AC power plug with wet hands, as this

could result in fire or shock,

- Power cords should be routed to avoid being severely bent,

pinched, or walked upon. Pay particular attention to the coral

from the unit to the power socket,

- Avoid overloading AC power plugs and extension cords

beyond their capacity, as this could result in fire or shock.

Extension cord — To help prevent electric shock, do not

use a polarized AC power plug with an extension cord,

receptacle, or other outlet unless the polarized plug can be

completely inserted to prevent exposure of the blades of the

plug,

When not in use — Unplug the AC power cord from the AC

power plug it the unit will not be used for several months or

more. When the cord is plugged in, a small amount of current

continues to flow to the unit, even when the power is turnecl

off

Outdoor Antenna

Power lines — When connecting an outdoor antenna, make!

sure it is located away from power lines.

Outdoor antenna grounding — Be sure the antenna systeml

is properly grounded to provide protection against unexpected

voltage surges or static electricity build-up. Article 810 of the

National Electrical Code, ANS1/NFPA 70, provides informatiorl

on proper grounding of the mast, supporting structure, ancl

the lead-in wire to the antenna discharge unit, as well as the

size of the grounding unit, connection to grcmnding terminals,

and requirements for grounding terminals themselves.

Antenna Grounding According to the National Electrical Code

I ~- ANTENNALEAD‘“ ““’

. ANTENNA DISCHARGE UNIT

(NEC SECTION 810-20)

ELECTRIC

GROUNDING CONDUCTORS

(NEC SECTION 810.21)

GROUND CLAMPS

~ POWER SERVICE GROUNDING

“EC-NATIONAL ELEC1-RICAL CODE

ELECTRODE SYSTEM

(NEC ART 250 PART H)

Maintenance

Clean the unit only as recommended in the Operating

Instructions.

Damaqe Reauirina Service

Have the units serviced by a qualified service technician if:

- The AC power cord or plug has been damaged

- Foreign objects or liquid have gotten inside the unit

- The unit has been exposed to rain or water

- The unit does not seem to operate normally

- The unit exhibits a marked change in performance

- The unit has been dropped, or the cabinet has been damageci

DO NOT ATTEMPT TO SERVICE THE UNIT YOURSELF.

❑

ENGLISH ;!

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Aiwa NSX-V8000 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 11,59 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Aiwa NSX-V8000 Manual

Product: