496590
57
Zoom out
Zoom in
Previous page
1/62
Next page
TROUBLESHOOTING GUIDE
Ifthe unit fails to perform as it is supposed to, by following this operation manual, please check it carefully in accordance with the table below:
,.
Correct the connection.
* Press the function button to select the correct input.
Correct the connection.
* Disconnect the AC cord, correct the condition,
including speaker connections, and connect the
AC cord again.
Disconnect the AC cord, correct the condition, in-
cluding speaker connections, and then connect the
power again. Turn on the power by pressing the
POWER button.
If the clock display is flashing, radio presetting or
timer settina has been canceled. Set it again.
The AC cord is not connected DroDerlv.
An incorrect function button is pressed.
There is a bad connection between systems.
Excessive voltage was applied to a speaker ter-
minal, which tripped the amplifier’s voltage-pro-
tection breaker.
There is a short circuit in the speaker terminal.
The breaker has tripped because of connection to
a low-impedance speaker.
One speaker is disconnected.
Correct the speaker connection.
c The antenna is not connected rm’o~erlv.
Check the antenna connection
The receiver is not correctly tuned,
Correct the tuning.
Thesignal is weak.
Install an outside antenna,
Change thelocation ordirection of the antenna.
Turn theunit toadifferent orientation,
Move the unit away from other electrical
appliances, like a TV or fluorescent lights, or move
the appliances.
* The system picks up outside noise.
There is multipath distortion.
Change the orientation of the antenna,
Replace the antenna with one that has the correct
orientation,
Press II and release pause.
The deck is on pause,
Clean the head.
‘1The sound is off-balance.
The rrlavback head is dirtv.
~ There are no high sounds.
The ~layback head is dirty.
Clean the head.
~~Recording is impossible.
The erasure prevention tab on the tape has
been broken off.
There is an incorrect connection.
Cover the erasure prevention hole with tape.
Correct the connection.
The recording head is dirty
Clean the head.
The erasure head is dirty.
c Clean the erasure head,
A metal or CrOz tape is used.
A KARAOKE function is selected.
Use a normal tape,
Cancel the KARAOKE function.
The disc is incorrectly inserted.
Insert the disc with the label facing up.
The disc is dirty.
Clean the disc.
There is condensation on the lens.
The ~laver is on ~ause.
Wait about an hour and trv aaain.
.“
Press the II button to release pause.
Cancel the KARAOKE function.
A KARAOKE function is selected.
To reset
If an unusual condition occurs, reset the unit as follows.
1 Press the POWER button to turn off the power.
2 Press the POWER button while pressing the
button.
Everything stored in memory after purchase is canceled.
3 Press the POWER button to turn on the power.
4 Set the clock, radio presetting and timer settings as before.
If the power cannot be turned off in step 1 because of a malfunction,
reset by disconnecting the AC cord and carry out steps 2 to 4.
59
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aiwa NSX-V20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aiwa NSX-V20 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 17,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info