496484

Aiwa NSX-A111 Manual

15
Zoom out
Zoom in
Previous page
1/56
Next page
,...
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly,
1
2
3
4
Press one of the function buttons to select a
source.
*
If TUNER/BAND is pressed, the band cannot be selected in
this step,
Press TIMER while pressing SHIFT on the remote
control so that G!)appears on the display.
Time and audio source name flash alternately.
@
Within 6 seconds, press+ or >> to designate
the timer-on time, then press 11.
Pressing either button changes both the hour and the minute.
Holding it down will vary the time rapidly by 10-minute interval,
and pressing it repeatedly will vary by 1 minute interval.
Within 4 seconds, press +< or > to select the
duration for the timer-activated period.
The duration can be set between 5 and 240 minutes in 5
minute steps.
The duration will be automatically set after 4 seconds. It will
also be set if II is pressed within 4 seconds after step 4,
5
6
7
8
Adjust the volume.
a
The source sound will play at the volume level set in this step
when the power is turned on by the timer.
;..
If the volume level is set to 17 or higher, however, it will
.j;~jl
automatically be set to 16 when the power is turned on,
;;~$
?
.?,
2~“
Prepare the source.
J::,.&
;g;;
To listen to a CD, load the disc to be played first on tray 1. ~~
8
‘“ ‘.“.
To
listen to a tape, insert the tape into deck 1 or 2.
?.
To listen to the radio, tune in to a station.
d
Press POWER to turn off the power.
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
Get ready for the tape function or the timer
recording.
To listen to the tape, press b.
To record the source, press
● on deck 1,
When the timer-on time is reached, the unit turns on and
begins play with the selected source, While the timer is in
operation, the display indication is dimmer than usual,
m
You can change the source that was selected in step 1 by
pressing one of the function buttons before pressing II in step
3.
The timer recording period and tape length
When the length of the tape to be recorded is shorter than the
timer recording period,
● on deck 1 is released before the timer
is off.
When the tape length is longer than the timer recording period,
● is not released. If ● is not released for a long time, the tape
in the deck may be damaged. Press W+ to release
● .
❑
To check the timer setting
Press TIMER while pressing SHIFT on the remote control.
The selected source, the timer-on time, and the duration for the
timer-activated period will be displayed for 4 seconds,
To change any of the previous setting
Carry out from step 1.
However, if you do not change the timer-on time, in step 3 just
press II twice and continue from step 4.
To cancel the timer standby mode temporarily
Press TIMER repeatedly while pressing SHIFT on the remote
control to display “[’{OFF.
To restore the timer standby mode, press again to display ~,
Using the unit while the timer is set
You can use the unit normally after setting the timer,
Before turning off the power, check whether the contents in step
5 and 6 are set as you wish, turn off the power and carry out step
8 if necessary,
m
● Timer playback will not begin unless the power is turned off.
● Connected equipment cannot be turned on and off by the built
in timer of this unit. Use an external timer.
ENGLISH
15
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aiwa NSX-A111 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aiwa NSX-A111 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 9,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info