SPECIFICATIONS TROUBLESHOOTING GUIDE
Main unit
FM
tuner section
Tuning range
Antenna terminals
AM tuner section
Tuning range
Antenna
Amplifier section
Power output
87.5 MHz
tO 108 MHz
75 ohms (unbalanced)
530 kHz to 1710 kHz (10 kHz
step)
531 kHz to 1602 kHz (9 kHz step)
Loop antenna
5W+5W(1 kHz, T.H.D. 10%,4
ohms)
3.5 W+ 3.5 W(100–15kHz,
T.H. D. less than 1 %, 4 ohms)
Cassette deck section
Track format
4 tracks, 2 channels stereo
Frequency response
Normal tape: 50 Hz – 12500 Hz
Recording system AC bias
Erasure system
Magnet erase
Heads
Recording/playback head x 1
Erase head x 1
Compact disc player section
Laser Semiconductor laser (Z= 780 nm)
D-A converter 1 bit dual
Wow and flutter Unmeasurable
Speaker system
Speakers
100 mm (4 in,) cone type, 4 ohms
Dimensions (W x H x D)
150 x 236.2 x 210.5 mm
(6x
93/8 x 83/~in.)
Weight
1,1 kg (2 Ibs 7
OZ.)
GeneraI
Power requirements 120 VAC, 60 HZ
Power consumption
22 w
Dimensions of main unit
160 x 236.2 x 209.3 mm
(W XHXD)
(63/8 X 9’/8 x 81/4 in.)
Weight of main unit
2.6 kg (5 Ibs 12
OZ.)
Specifications and external appearance are subject to change
without notice.
NOTE
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communi-
cations. Howeverj there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
CAUTION
Modifications or adjustments to this product, which are not
expressly approved by the manufacturer, may void the user’s
right or authority to operate this product.
If the unit fails to perform as described in these Operating
Instructions, check the following guide.
GENERAL
There is no sound.
. Is the AC cord connected properly?
● Is there a bad connection? (+ page 3)
● Was an incorrect function button pressed?
The sound becomes inaudible.
● There may be a short circuit in the speaker terminals.
+ Disconnect the AC cord from the AC outlet and re-connect
the speaker cords correctly, Then connect the AC cord and
turn the unit on again.
Sound is emitted from one speaker only.
● Is the other speaker disconnected?
TUNER SECTION
There is constant, wave-like static.
o Is the antenna connected properly? (+ page 3)
The reception contains noise interferences or the
sound is distorted.
● Is the system picking up external noise or multipath distortion?
+ Change the orientation of the antenna.
A Move the unit away from other electrical appliances.
CASSETTE DECK SECTION
The tape does not run.
“ Is
the deck in pause mode? (~ page 8)
The sound is off-balance or not adequately high.
● Is the playback head dirty? (+ page 11)
Recording is not possible.
● If the tab on a cassette broken off, cover the hole with adhesive
m
tape,
e
Side A
‘<@ *
\ (a>
4
Tab for side A
● Is the recording head dirty? (+ page 11)
Erasure is not possible.
● Is the erasure head dirty? (+ page 11)
● Is a Cr02 or metal tape being used?
High frequency sound is not emitted.
● Is the recording/playback head dirty? (+ page 11)
CD PLAYER SECTION
The CD player does not play.
● Is the disc correctly loaded ? (+ page 5)
● Is the disc dirty? (+ page 11)
● Is the lens affected by condensation?
+ Wait approximately one hour and try again
CLOCK AND TIMER SECTION
Timer setting is not possible.
● Does the clock flash on the display ?
+ Reset the clock. (+ page 9)
To reset
If an unusual condition occurs in the display window or the
cassette decks, reset the unit as follow.
1 Press the POWER button to turn off the power.
2 Press the POWER button to turn the power back on while
pressing the
❑ button. Everything stored in memory after
purchase is canceled.
If the power cannot be turned off in step 1 because of a
malfunction, reset by disconnecting the AC cord and repeat step
2.
ENGLISH
12
