496498
23
Zoom out
Zoom in
Previous page
1/76
Next page
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
Occasional care and maintenance of the unit and the software
If the unit fails to perform as described in these Operating
are nseded to optimize the performance of your unit.
Instructions, check the following guide.
To clean the cabinet GENERAL
Use a soft and dry cloth.
There is no sound.
If the surfaces are extremely dirty, use a soft cloth lightly Is the AC cord connected properly?
moistened with mild detergent solution, Do not use strong
Is there a bad connection? (+ page 3)
solvents, such as alcohol, benzine or thinner as these could
There may be a short circuit in the speaker terminals,
dama,ge the finish of the unit. + Disconnect the AC cord, then correct the speaker
connections,
TCIclean the heads and tape paths
Was an incorrect function button pressed?
After every 10 hours of use, clean the heads and tape paths
Sound is emitted from one speaker only.
with a head cleaning cassette or cotton swab moistened with Is the other speaker disconnected?
cleaning fluid or denatured alcohol. (These cleaning kits are
The output sound is not stereo.
commercially available.)
IS the Karaoke function turned on? (+ page 17)
When cleaning with a cotton swab, wipe the recording/playback
An erroneous display or a malfunction occurs.
%
head, erasure head (deck 2 only), capstans, and pinchrollers.
+ Reset the unit as stated below,
#——
%
After cleaning the heads and tape paths with a liquid head
cleaning cassette or a moistened swab, wait until the cleaned
parts are completely dry before inserting the tapes.
To demagnetize the heads
The Iheads may become magnetized after long-term use. This
may narrow the output range of recorded tapes and increase
noise. After 20 to 30 hours use, demagnetize the heads with
any commercially available demagnetizer,
TUNER SECTION
There is constant, wave-like static.
c Is
the antenna connected properly? (+ page 4)
Is the signal weak?
+ Connect an outdoor antenna.
The reception contains noise interferences or the sound
is distorted.
Is the system picking up external noise or multipath distortion?
+ Change the orientation of the antenna,
+ Move the unit away from other electrical appliances.
CASSETTE DECK SECTION
The tape does not run.
Is deck 2 in pause mode? (+ page 10)
The sound is off-balance or not adequately high.
Is the playback head dirty? (+ page 22)
Recording is not possible.
Is the erasure prevention tab on the tape broken off? (+ page
1
o)
[s the recording head dirty? (+ page 22)
Erasure is not possible.
Is the erasure head dirty? (+ page 22)
Is a metal tape being used?
High frequency sound is not emitted.
Is the recording/playback head dirty? (+ page 22)
Care of discs
CD PLAYER SECTION
When a disc becomes dirty, wipe the disc from the center out
The CD player does not play.
with a cleaning cloth.
Is the disc correctly inserted? (+ page 11)
Is the disc dirty? (+ page 22)
IS the lens affected by condensation?
+ Wait approximately one hour and try again
e Aftlsr playing a disc, store the disc in its case. Do not leave the
disc in places that are hot or humid,
Care of tapes ,
*
Stc]re tapes in their’ cases after use.
e Do not leave tapes near magnets, motors, television sets, or
any source of magnetism. This will downgrade the sound quality
and cause noise.
o Do not expose tapes to direct sunlight, or leave them in a car
parked in direct sunlight,
To reset
If an unusual condition occurs in the display window or the
cassette decks, reset the unit as follows.
1 Press the POWER button to turn off the power.
2 Press the POWER button to turn the power back on while
pressing the
CLEAR button. Everything stored in memory
after purchase is canceled.
If the power cannot be turned off in step 1 because of a malfunction,
reset by disconnecting the AC cord, and connect it again. Then
repeat step 2.
ENGLfSH
22
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aiwa CX-NA31 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aiwa CX-NA31 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 13,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info