496627
12
Zoom out
Zoom in
Previous page
1/52
Next page
12
TROUBLESHOOTING
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check the
connection and operating procedures.
General
No sound.
•Turn (PUSH-MENU) to the right to adjust the
volume.
Cancel the ATT function.
Set the fader control to the center position for a 2-
speaker system.
The contents of the memory have been erased.
The reset button has been pressed.
t Store again into the memory.
The power lead or battery has been disconnected.
The power connecting lead is not connected
properly.
No beep sound.
The beep sound is canceled (page 10).
An optional power amplifier is connected and
you are not using the built-in amplifier.
The display disappears from/does not appear
on the display window.
The display disappears if you press and hold
(OFF).
t Press and hold (OFF) again until the display
appears.
Remove the front panel and clean the connectors.
See “Cleaning the connectors” (page 16).
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the ignition key is in the ON,
ACC, or OFF position.
The leads are not matched correctly with the car’s
accessory power connector.
No power is being supplied to the unit.
Check the connection. If everything is in order,
check the fuse.
The car does not have an ACC position.
t Press (SOURCE) (or insert a disc) to turn on
the unit.
The power antenna does not extend.
The power antenna does not have a relay box.
Radio reception
Preset tuning is not possible.
Store the correct frequency in the memory.
The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
Connect a power antenna control lead (blue) or
accessory power supply lead (red) to the power
supply lead of a car’s antenna booster (only
when your car has built-in FM/AM antenna in
the rear/side glass).
Check the connection of the car antenna.
The auto antenna will not go up.
t Check the connection of the power antenna
control lead.
Check the frequency.
Automatic tuning is not possible.
The local seek mode is set to “ON.”
t Set the local seek mode to “OFF” (page 7).
The broadcast signal is too weak.
t Perform manual tuning.
A program broadcast in stereo is heard in
monaural.
t Cancel monaural reception mode (page 7).
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aiwa CDC-X504MP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aiwa CDC-X504MP in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info