638708
4
Zoom out
Zoom in
Previous page
1/9
Next page
TEMPERATURE SENSOR SELECTOR
Under normal conditions the room temperature
is detected and checked by the temperature
sensor placed in the air conditioner.
Press the remote control I FEEL button to
activate the temperature sensor placed in
the remote control. This function is designed
to provide a personalised environment by
transmitting the temperature control command
from the location next to you. Therefore, in
using this function, the remote control should
always be aimed, without obstruction, at the air
conditioner.
OPERATION WITH THE REMOTE CONTROL UNIT
Check that the circuit breaker on the power
panel is turned ON and the STANDBY lamp is
light up.
When using the remote control unit, always
point the unit transmitter head directly at the air
conditioner receiver.
HOW TO TURN ON THE AIR CONDITIONER
Press the ON/OFF button to turn the air
conditioner on. The indicator OPERATION will
light up, indicating the unit is in operation.
NOTE
The remote control unit sends the temperature signal to the air morf
langis eht fI .slavretni etunim owt ta ylraluger renoitidnoche remote
control unit stops for more than ve minutes due to some troubles,
the air conditioner will switch to the temperature ensor which is built
into the indoor unit and controls the room temperature. In these cases,
the temperature around the remotecontrol unit may differ from the
temperature detected in the air conditioner position.
REMOTE CONTROL
UNIT DISPLAY
USING THE REMOTE CONTROL UNIT
USING THE REMOTE CONTROL UNIT
HOW TO INSTALL BATTERIES
Remove the lid in the rear part of the remote
control unit.
Insert two AAA alkaline batteries of 1,5 V-DC.
Make sure to insert the batteries according to the
polarity(+/-)
marked in the battery compartment.
Push the lid back on.
Remove the lid in the rear part.
Press the battery toward the negative end
and lift it out by its positive end as shown.
General Note:
Remove the other battery in the same way.
HOW TO REMOVE BATTERIES
Replace the batteries when the remote control unit lamp fails to light, or when the air conditioner does not receive the
remote control unit signals.
Remove the batteries if you do not use the remote control unit for more than one month.
The batteries last about six months, depending on how much you use the remote control unit.
The batteries of the remote control contain polluted substances exhausted batteries must be disposed according to the
laws in force.
After batteries change:
Press the +,-, SET and CLEAR buttons together.
( After batteries change the remote control needs to be
reset to ensure proper functioning. By pressing above
mentioned buttons, remote control programs are reset.)
The button+, - refered to above is the buttons for
setting the hour not
temperature.
3
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Airwell RC3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Airwell RC3 in the language / languages: English as an attachment in your email.

The manual is 4,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Airwell RC3

Airwell RC3 User Manual - German - 9 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info