593975
11
Zoom out
Zoom in
Previous page
1/19
Next page
9
7. OPERATION PROCEDURES
Daily start-up Procedures
1. Set the Auto-On/Off lever to the Off position.
2. Check the air compressor visually for any damage or obstruction.
3. Close the drain valve.
4. Check the oil level of the pump.
5. Attach the air hose to the quick coupler by pulling back on the outer sleeve of
the quick. Release the outer sleeve and make sure the hose stays in place.
6. Plug the power cord into the proper receptacle.
7. Install the desired air accessory to the open end of the air hose before
proceeding any further. Failure to do so will not allow any pressure to build
up in the hose.
8. Turn the Auto-on/Off lever to the On-Auto position and the compressor will
start and build air pressure in the tank to cut-out pressure and then shut off
automatically.
9. Adjust the regulator to a bar/PSI setting that is needed for your application
and be sure it is within the safety standards required to perform the task. If
using a pneumatic tool; the manufacturer should have recommendations in
the manual for the particular tool on operating PSI settings.
Daily Shut-Down Procedures
1. Unplug the power cord from the receptacle.
2. Set the outlet pressure to zero on the regulator.
3. Remove any air tools or accessories. When draining the tank, always use
ear and eye protection. Drain the tank in a suitable location; condensation
will be present in most cases of draining.
4. Open the drain valve allowing air to bleed from the tank. After all of the air
has bled from the tank, close the drain valve to prevent debris buildup in the
valve.
CAUTION
When draining the tank, always use ear and eye protection. Drain the tank in a
suitable location; condensation will be present in most cases of draining.
WARNING
Water that remains in the tank during storage will corrode and weaken the air
tank, which could cause the tank to rupture. To avoid serious injury, be sure to
drain the tank after each use or daily.
8. MAINTENANCE
NOTE: Qualified service personnel should perform any service procedure not
covered in the maintenance schedule below.
ITEMS TO CHECK/CHANGE Before each
use or daily
After first
ten hours
Every 100
hours
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Airpress 36646 - LHR 215-5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Airpress 36646 - LHR 215-5 in the language / languages: English as an attachment in your email.

The manual is 1,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Airpress 36646 - LHR 215-5

Airpress 36646 - LHR 215-5 User Manual - English, German, Dutch, French - 56 pages

Airpress 36646 - LHR 215-5 User Manual - Spanish - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info