594023

Airpress 36522 Manual

32
Zoom out
Zoom in
Previous page
1/56
Next page
30
pressure gauge (4). The reduction/filter combination also cleans air from oil and
water drops.
L and LM types:
In the connection box (9) at the motor, a thermal protection has been attached.
This device turns off the compressor automatically, to protect the motor from
overheating. By pressing the red reset button (10) at the bottom of the box after a
little time, the compressor is ready to function again (type LM 100-400 has the
thermal protection device on top of the motor).
KM types:
The 400 volts electric motor of your compressor is protected against overheating
by a combined switch + reset button (2). This device turns off the motor
automatically if the motor should get overloaded or if one phase should fall out. By
pressing the black reset button after a short time, the compressor will function
again. If repeating thermal failure should occur, see chapter 7.0 Possibilities of
failure.
5.2 OPERATING
Check if the pressure switch has been set off. Then connect the machine to
your electric circuit. Set the pressure switch to on. If the pressure in the air
tank is below the pressure to start the machine, the compressor automatically
will start until the pressure to stop the machine has been reached. If the
pressure is high enough, the compressor will not start but will remain stand-by
until pressure drops below the point to start the machine.
To accomplish a continuous working pressure, the machine is equipped with a
reduction valve. With this device, you can reduce the air tank pressure to any
desired working pressure. Therefore, pull the button out of the interlocking and
turn left for a lower pressure and right for a higher pressure. Of course, the
working pressure can never be higher than the air tank pressure.
Turning off your compressor, you should always first turn the pressure switch
off before you pull out the plug. This way the pressure switch relieves the air
from the internal air circuit, so that the compressor can run freely when it is to
be turned on again. This protects the motor from damage.
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Airpress 36522 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Airpress 36522 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info