521963
20
Zoom out
Zoom in
Previous page
1/47
Next page
offered by Busse-Yachtshop.com
AIR 403 Land Manual Document #0049 REV D
SOUTHWEST WINDPOWER 8/20/2001 20
3.3.2 Mounting the Hub and Rotor
CAUTION: THE BLADES ARE SHARP. USE CAUTION WHILE HANDLING THE BLADES.
Remove the 5/8” nut from the alternator shaft. Carefully slide the blade assembly onto the
alternator shaft. Place the nut on the shaft and thread the nut on by spinning the blade
assembly. Insert the 5/16” hex key torque wrench into the alternator shaft and tighten the nut
by holding the hub set and tightening the shaft with the torque wrench. The nut should be
tightened to 50 - 65 foot pounds (68 – 88 Nm). When the blade set assembly is tightened,
spin it to be sure it turns freely.
3.3.3 Attaching Nose Cone
Carefully place the nose cone over the center of the hub and the blades. Snap the nose
cone into place. Be sure all three edges catch. Check to see that the nose cone is secure by
firmly pulling on it. The nose cone does not affect the performance of the turbine and may
be left off, if desired.
3.4 Step-By-Step Instructions
The following Step-By-Step-Installation-Procedures provides you with an outline of the AIR
403 installation process. This consolidated reference should only be used as an outline
during installation. Refer to the appropriate sections for further details.
1) Run the wires from the battery (do not connect to the battery), through the pole to the top
of the tower. Be sure not to connect the wires to the battery until everything else has
been completed.
2) Strip the insulation back from each set of wires.
3) Mark both ends of all the wires with tape to identify which is negative, positive and earth
ground.
AIR 403 color-codes:
RED = Positive
BLACK = Negative
GREEN = Ground.
4) Insulate the connections using either heat shrink tubing or a quality electrical tape.
5) Connect the wires from the AIR 403 to the wires running to the battery.
CAUTION: IF THE WIRES ARE HOOKED-UP BACKWARDS YOU WILL DAMAGE
THE AIR 403’S ELECTRONICS. (IF YOU ARE UNCERTAIN OF THE POLARITY OF
THE WIRES, SIMPLY SPIN THE ROTOR SHAFT AND MEASURE THE VOLTAGE
DIRECTION WITH A VOLT METER).
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Air Marine Air 403 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Air Marine Air 403 in the language / languages: English as an attachment in your email.

The manual is 0,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info