496137
25
Zoom out
Zoom in
Previous page
1/28
Next page
-
Page 45
-
Note: You can find and download the complete Installation guide at
our web site www.aiptek.de under "Technische Hilfe / Anleitungen"
Win98-Users: Please be sure that your operating system is Windows
98 SE (second edition). The camera will not function properly using
the Windows 98 (first edition) operating system
¾ The Live Mode functions properly but downloading pictures and
videos in not possible.
This problem could occur if the drivers were not properly installed. The
drivers include three components that windows will automatically
install and integrate into your system one after another. If one or more
components were improperly installed, some features may not
available or operate correctly
Note: You can find and download the complete Installation guide at
our web site www.aiptek.de under "Technische Hilfe / Anleitungen"
.
¾ When I open the Mega Cam Manager I receive the message
”Camera can not be connected” or “Camera busy”.
If you receive this message, there could be a number of reasons for
this problem. Please refer to the following possibilities:
When you connect the camera to the USB – Port, the camera should
automatically turn on (check the display on the reverse side of the
camera). Remove the batteries from the camera and connect –
disconnect – connect the camera from the USB Cable. You should
hear a short beep and the camera should turn on automatically.
If the camera remains off, then the camera is most likely defect or the
USB Port is not supplying enough power to the camera. Try installing
the camera to a different computer if possible. If the camera installs
properly then the problem is due to a faulty operating system.
Ensure that the camera has been correctly recognised by your
operating system. Go to the Device Manager and connect the camera
to the USB Cable. Three new components should appear, one under
Cameras and Scanners and two under Universal Serial Bus
Controller. If not then the camera has not been properly recognised.
Note: You can find and download the complete Installation guide at
bit itkd d "T h i h Hilf / A l it "
-
Page 46
-
¾ While in the PC-Mode, the picture freezes after a couple of
seconds.
This problem could occur with cameras that have an older main board.
A modification of the main board is necessary. Please contact your
dealer or send the camera directly to us (Only for customers living in
Germany).
¾ The PC crashed when making videos from the PC-Mode using
Windows 98SE
This problem can occur when the DMA of the hard drive controller is not
activated (Windows 98SE default setting).
Do the following to check the DMA-mode setting:
Open the device manager and click on the “+” next to the entry “drives”.
Double click on “GENERIC DISK TYPE” then click on “Settings”.
Under “Options” you will see a box next to DMA. Click on this box to
activate the DMA-mode. You must reboot the computer in order for the
changes to take effect.
Attention: Not all hard drives support the DMA-mode. Refer to your
manual or contact the manufacture to see if your hard drive is
supported.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aiptek mini pencam plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aiptek mini pencam plus in the language / languages: English as an attachment in your email.

The manual is 2,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Aiptek mini pencam plus

Aiptek mini pencam plus User Manual - German - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info