729482
9
Zoom out
Zoom in
Previous page
1/16
Next page
The temperature of the hot water supplied can be
adjusted by means of the boiler thermostat knob. This
knob can also be used to turn the boiler off.
To inhibit internal corrosion of the boiler heat exchanger it
is important not to operate the boiler below 60°C.
An ideal setting for summer hot water; and to keep the
temperature above 60°C, can be achieved using the
‘ECO’ setting.
‘ECO’ SETTING
The ‘ECO’ setting on the boiler is a range at which the
boiler operates at maximum efficiency.
The boiler thermostat knob is situated behind the control
door (See Fig. 2). Turn the knob clockwise to increase the
temperature of the water.
Should your heating water system be of an unvented
design i.e. Pressurised System. It is important not to keep
resetting the boiler safety cut-out as this may indicate a
loss of secondary water.
Check also your system pressure gauge.
FROST PRECAUTIONS
In the event of the boiler being OFF for long periods
during very cold weather, the advice of your installer
should be obtained.
THE BURNER
If a fault occurs on either burner then a fault code is
displayed and shuts down the part of the appliance with a
fault (cooker or boiler).
This can be re-set after 1 minute by pressing the REPEAT
button.
In the event of repeated failure switch off the oil and
electrical supply to the appliance and contact the installer/
service engineer.
WHAT IT DOES
The Rayburn programmer is a 7-day 2 event programmer
which allows the user to set 2 periods of the day in which
the cooker will turn on and then off, A typical example
of how this may be used is ‘on’ for use in the morning
and then ‘off’ when going out, and then ‘on’ if needed for
cooking later in the day and then ‘off’ when cooking is
finished.
The programmer can be set for different time each day
(e.g. morning and evening). However, as many people
have a similar routine through the working week, there
is a repeat function which allows the setting from the
previous day to be copied.
However, it may still be set each day differently.
FUNCTIONS
The AUTO/MAN functions allow the user to turn the
cooker on, by simply turning the knob to the required
cooking mark temperature, or by having it turn on at 2 set
periods within the day.
The minute minder function works as a countdown timer
to ease with cooking. When the timer has counted down
the display will flash 00:00 and a buzzer will sound.
SETTING INDIVIDUAL DAYS
To allow the user to change an individual day without
having to run throughout the entire week, there is the
ability to change just one day (e.g. days holiday) without
altering the previous settings.
1. Press the CLOCK button once. Adjust the day using
+ and -. Press the CLOCK again.
2. Adjust the hour using + and -. Press CLOCK again.
3. Adjust the minutes using + and -. Press CLOCK to
confirm.
The day light will go out
PLEASE NOTE: Hold + and - down to increase or
decrease.
9
THE BOILER THE PROGRAMMER
SETTING THE TIME OF DAY
: flashes when time is set
Fig. 5 DESN 514714
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aga Rayburn 760 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aga Rayburn 760 in the language / languages: English as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info