801252
25
Zoom out
Zoom in
Previous page
1/40
Next page
``
25
When a turn indicator is activated, the applicable LED will flash.
Depending on the model, a buzzer may also sound (subject to local
regulations). To turn off the indicator, press the button again.
Buzzer
buttons (1.14)
Push one of the 2 Buttons (1.14) to activate the buzzer.
The buzzer sounds automatically under the following conditions (except
where prohibited by law),:
1. When reversing
2. When operating the left or right indicator
Remark: It is possible to change the Buzzer functionality by
changing a dip switch in the front board .This needs to be done
by an authorized technician.
Headlight
switch (1.13)
To turn on the headlight and rear lights, press the Lights button (1.13).
When the lights are ON the lights led (5.6) is lit.
To turn off the lights, press the button again.
Hazard
button (1.16)
The Hazard button activates all the flashing lights on AFISCOOTER C.
To turn off the hazard lights, press the button again.
When the hazard lights are activated, both LEDs (5.3 & 5.4) flash.
Inhibit while
charging
When AFISCOOTER C is being charged, it is in inhibiting mode. In this
mode it cannot be driven. When being charged a signal will be lit.
Safe driving /
Half speed
switch (1.11)
When driving on ramps, high curbs and on sharp turns, drive very slowly
and carefully, consider changing the Half Speed Switch (1.11) to Half
speed mode. Never try to go over an obstacle that is more than the
maximum recommended slope angle, and obstacle height given in the
specification sheet.
Always drive carefully and adjust your speed to the road conditions.
Before making sharp turns, reduce AFISCOOTER C speed, to Half
Speed, to prevent side roll-over.
LCD (5.1)
When driving and operating the AFISCOOTER S, all the required
information is displayed on the LCD screen
MODE and
RESET
button
(1.21)
The MODE / RESET button will change the digital reading from Speed to
Travel Distance or Time. The distance is shown in km, or miles and the
time displayed in hours.
(Note: Setting the speed unit can be done by a technician.
When you push the MODE button to the modes: "travel time" and "travel
distance" and keep pushing it for more than 7 seconds, the "travel time"
and "travel distance" will reset to zero.
Setup button
(1.22)
The Setup button is used to set the clock.
Parking
After stopping AFISCOOTER C, turn the key switch (1.17) to OFF and
remove the key. The LED will turn OFF.
Note: The EMB locks automatically when the throttle control lever is
released and AFISCOOTER C has come to a complete stop.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Afikim AfiScooter C plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Afikim AfiScooter C plus in the language / languages: English as an attachment in your email.

The manual is 2.44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info