618075
104
Zoom out
Zoom in
Previous page
1/124
Next page
104
Display Module Battery Installation
Slide a new 3 volt type CR2450 Lithium Battery, negative (-) side
down into the Battery Cavity. Slide it in from the right side and
ensure that it slides under the contact clip on the left rim of the
cavity (Fig. 101).
Orient the Retaining Bar across the lower portion of the Battery
and carefully push it down into position.
Replace the Hatch O-ring with a new one. This O-ring must be a
genuine Oceanic part that can be purchased from an Authorized
Oceanic Dealer. Use of any other O-ring will void the warranty.
Lightly lubricate the new Hatch O-ring with silicone grease and
place it on the inner rim of the Battery Hatch. Ensure that it is
evenly seated.
Slide the Hatch Ring, top portion first (small opening), onto your
thumb (Fig. 102).
Carefully place the clear Battery Hatch (with O-ring) into position
on the rim of the Battery Compartment, then press it evenly and
completely down into place with your same thumb.
Maintain the Battery Hatch securely in place and, using your other
hand, slide the Hatch Ring down off your thumb and into position
around the Battery Compartment. The Tabs on the Ring fit down
into the slots located at the 2 and 9 o'clock positions.
Turn the Ring counter clockwise 5 degrees until the Tabs engage,
then tighten it 5 more degrees by turning it counter clockwise with
the aide of a small blade screwdriver or Hatch Ring Tool, pressing
against the upper/left arm of the Ring (Fig. 103).
Fig. 101 - Display Module
Battery Installation
Fig. 102 - Preparing for Hatch
Ring Installation
Fig. 103 - Tightening Hatch Ring
104


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aeris Atmos Elite at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aeris Atmos Elite in the language / languages: English as an attachment in your email.

The manual is 2,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info