456923
27
Zoom out
Zoom in
Previous page
1/42
Next page
English
27
Overview of the Components
1 Control
2 Thermostat
3 Control lamp
Instructions for Use
Use
Use the electric blanket on the mattress of your bed.
The electric blanket must be attached to the mattress by
means of the straps.
Place the electric blanket on the mattress (see Figure
A).
Release the straps and guide them under the mattress
(see Figure B).
Pass the straps through the loops on the other side of
the electric blanket and fasten them with knots.
The electric blanket must lie smoothly on the
mattress and must not be tucked in or contain any
creases.
Pass the lead out of the bed in such a way that you
can still operate the thermostat.
WARNING:
Under no circumstances should the thermostat be
covered by bedding or cushions! Otherwise this might
result in a malfunction.
Electrical Connection
Please ensure that the device voltage (see type plate)
and mains voltage are the same.
Insert the mains plug into a properly installed 230 V,
50 Hz socket with earthing contact.
Switching on
Move the regulator on the thermostat (2) to the
desired setting.
The control lamp (3) lights up and shows that the
device is working.
ޥ NOTE:
On the  rst few occasions that this device is used
unusual odours may be produced. These are harmless
and disappear the more the device is used.
Thermostat Settings
You can select from the following settings:
Setting Function Instructions for Use
0 O
1
Low. Slight
warmth.
Suitable for operation
during the night.
2 Medium
Suitable for operation
during the night.
3 High
Not suitable for
operation during
the night. Only for
warming up the bed
before getting into it.
ޥ NOTE: You can read o the setting on the control
lamp (3).
Switching o
Turn the thermostat control to 0 (o ).
Only then should you remove the plug from the
mains socket.
Cleaning
WARNING:
Always remove the mains plug from the socket before
cleaning the device.
CAUTION:
The electric blanket together with the thermostat
must not be placed in the washing machine or dry-
cleaned.
Do not immerse the components in water.
The thermostat must not be allowed to become
wet.
If you use water to clean the electric blanket, this
must not be warmer than 30°C. Otherwise the
material could shrink and damage the electrical
system.
Do not use any abrasive cleaners or solvents.
Do not use any stain remover such as foam or
spray.
Removing Stains from the Electric Blanket
• Wipe o the a ected area with a damp cloth or
sponge. In the case of stubborn stains a gentle soluti-
on of soapy water may be used.
Excess water can be dabbed o with a towel.
Drying the Electric Blanket
After cleaning, allow the material to dry in the air.
To this purpose the entire electric blanket should be
hung over a line.
Do not use any pegs or similar items.
05-WUB 5511 AEG.indd 2705-WUB 5511 AEG.indd 27 24.07.2008 14:48:56 Uhr24.07.2008 14:48:56 Uhr
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG WUB 5511 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG WUB 5511 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish, Norwegian as an attachment in your email.

The manual is 0,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info