Manual AEG WSP 300 H (page 38 of 76) (English, German, Dutch, French)

464372

Zoom out

Zoom in

1/76

For the Fitter

Fig. 23

Fig. 24

●

Remover the screws (Pos. 25, Fig. 23) from the

top part of the slide-in fan module.

●

Remove the tape covering the cable conduit

hole and insert the cable conduit from the

outside (Pos. 26).

●

Position the day-acting element E2 (Fig. 24)

from the rear into the slide-in fan module,

threading the cable ends to the outside.

Position the element holding lugs accordingly

and fix them with the screws provided.

●

Screw the earth wire (Pos. 27) into position on

the front left hand side of the slide-in fan

module.

●

Replace the base board. Reconnect the room temperature sensor B2 cables to the charge and

discharge regulator B1. Retighten the pressure screws.

●

Connect the earth wire to the switching panel. Connect up the cables from the “switching

thermostat”, the “safety cut-out” and the day-acting element according to the circuit diagram

(page 31).

Caution: Make sure that no wiring is damaged or removed or is touching the fan

resistance. Run the wires accordingly, so that this does not happen.

Caution: Before replacing the front cover panel, make sure that the core temperature sensor B3

(see Fig. 6, page 32) is firmly sitting in its sleeve (sensor tip at end of sleeve).

●

Replace the front cover panel and the operating panel.

●

Reconnect the power supplies and check the function of the day-acting element.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of AEG WSP 300 H in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

AEG WSP 300 H Manual

Product: