464372
22
Zoom out
Zoom in
Previous page
1/76
Next page
22
For the User
1. Operating Instructions
1.1 Technical Description
Storage heaters store electrically generated heat during low-cost electricity tariff periods
(depending on the electricity supply company, mainly during the night hours). This is then
discharged according to the desired room temperature as hot air by a fan.
1.2 Operation
The heater is operated using the recessable knobs on the top right of the heater. Pressing the knobs
gently inwards causes them to spring outwards, further pressure causes them to recess back into
the heater. The knobs can be recessed in any set position.
Left hand knob = Charge control adjustment
Right hand knob = Room thermostat adjustment
1.2.1 Heat storage
Heat storage takes place automatically. The residual heat left over from the previous day is always
taken into account by the charge and discharge control during heater charging.
Automatic charge control
The heater charge adjusting knob should always be set at MAX (fully clockwise). If the charge
should be reduced for any reason, this can be done by turning the knob slightly down. Any changes
made to the settings will only be noticed on the following day. Do not, therefore, make too bigger
changes to the settings.
The heat stored by the complete system is determined by the central charge control (in the
distribution box). Please refer to the operating instructions which come with central charge control
to adjust these settings.
Manual charging
If the heater is not connected to a central charge control, the amount of heat to be stored can be
determined by the infinitely variable charge adjusting knob on the heater itself:
no heat storage: fully anticlockwise
full heat storage: fully clockwise
Once the set amount of heat has been stored, the heater switches off independently.
1.2.2 Heat discharge
The heat discharge is controlled by the charge and discharge control. If the room temperature sinks
below the set temperature, the heater fan switches on and dissipates warm air into the room until
the set temperature has been reached.
Day-acting element heater switch
This switch switches the day-acting element on and off. If no day-acting element is fitted, the
switch has no function.
1.2.3 Summer operation
In the summer months, the operating knobs for charge and discharge and for the room
temperature should be set to MIN (fully anticlockwise). Do not switch off the central charge
control circuit breaker as this could cause the time clock in the central control to go out of
synchronisation.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG WSP 300 H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG WSP 300 H in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info