463288

AEG WS 125 S Manual

2
Zoom out
Zoom in
Previous page
1/23
Next page
GB
1 WSL 115 XS, WSL 125 X, WS 100 S, WS 115 S, WS 125 S
Your standards are high and you have opted for
quality from Atlas Copco.
Make good use of your new electric power tool, we
have built it with great care, but first read the
instruction booklet.
A power tool only performs at its best when
properly handled.
AEG Electric Power Tools from Atlas Copco
1 Illustrations
1 Spindle lock
2 Gear neck
3 Working spindle
4 Screw
5 Guard
6 Back flange
7 Working tool
8 Flange nut
9 Steel–wire brush (Accessory*)
10 On-/off switch
11 Additional side handle
12 Backing pad (Accessory*)
13 Abrasive paper (Accessory*)
14 Clamping flange (Accessory*)
15 Guide shoe and Wheel guard (Accessory*)
*Not included in standard equipment, available as an accessory
2 Technical data
WSL 115 XS WSL 125 X WS 100 S WS 115 S WS 125 S
Nominal power 710 W 710 W 710 W 710 W 710 W. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
No-load speed 10 000 min
–1
10 000 min
–1
10 000 min
–1
10 000 min
–1
10 000 min
–1
. . . . . . . . . . . . . . .
Grinding disc diameter 115 mm 125 mm 100 mm 115 mm 125 mm. . . . . . . . . . . . . . . . . . . . . . . .
Backing pad diameter 110 mm 110 mm – 110 mm 110 mm. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Thread of working spindle M 14 mm M 14 mm M 10 mm M 14 mm M 14 mm. . . . . . . . . . . . . .
Weight 1,6 kg 1,6 kg 1,6 kg 1,6 kg 1,6 kg. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3 Safety Instructions
Please note safety instructions on red sheet
4000 3330 24!
Appliances used at many different locations
including open air must be connected via a
current surge preventing switch.
Always wear goggles when using the machine. It
is recommended to wear gloves, sturdy non
slipping shoes and apron.
Do not pierce the motor housing as this could
damage the double insulation (use adhesives).
Always disconnect the plug from the socket
before carrying out any work on the machine.
Keep mains lead clear from working range of the
machine. Always lead the cable away behind you.
Only plug-in when machine is switched off.
Always use the additional handle.
Only use diamond cutting discs that are sharp
and in perfect condition. Replace diamond cutting
discs at once if they have splits or are deformed.
Accessories must be limited to 10,000 rpm.
When cutting stone, a guide has to be used.
Always use guard when grinding or cutting.
Due care should be taken that sparks flying from
the work piece do not contact inflammable
materials.
Before setting the machine into motion tighten
flange nut.
In special cases e. g. when the machine is used
under extreme humid conditions or is very
contaminated with conductive dusts, we
recommend the use of an ELCB safety switch
(earth leakage circuit breaker) to increase your
personal safety.
Typically the A-weighted sound pressure level of
the tool is 85 dB (A).The noise level when
working can exceed 85 dB (A). Wear ear
protectors!
Typically the weighted acceleration is :
3 m/s
2
(
WSL 115 XS, WS 100 S, WS 115 S)
4 m/s
2
(
WSL 125 X, WS 125 S)
Do not use this product in another way as stated
for normal use.
2 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG WS 125 S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG WS 125 S in the language / languages: English, German, Dutch, French, Italian, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info