Manual AEG TBS TB 50 THERMO BODEN (page 21 of 76) (English, German, Dutch, French)

648290

Zoom out

Zoom in

1/76

Installation – for qualied contractors

» Apply the tile adhesive and levelling compound if

applicable. Take care not to damage the heating

conductor.

» Make sure that the entire circumference and length

of the heating conductor is enclosed in tile adhesive.

» If necessary, lift the heating mat slightly after ap-

plying the tile adhesive to make sure that there are

no air bubbles beneath the heating mat. These may

lead to higher temperatures.

» Press the heating mat back down into the tile

adhesive.

» Lay the tiles in accordance with the manufacturer's

instructions.

9.6.2 Carpet, PVC, parquet or cork

Before laying oor coverings such as carpet, PVC or cork,

cover a large area of the heating mat with a levelling com-

pound.

The levelling compound provides mechanical protec-

tion for the heating mats. Appropriate materials include

free-owing cement mortar, for example.

» Choose an appropriate levelling compound. Note

that this must be able to withstand constant tempera-

tures of at least 80 °C.

» Seal the conduits so that levelling compound can-

not get into the conduits whilst installing the heating

mats.

» Apply the levelling compound in a 5-10 mm

thick layer. Take care not to damage the heating

conductor.

» Make sure that the entire circumference and length

of the heating conductor is enclosed in levelling

compound.

» If necessary, lift the heating mat slightly after apply-

ing the levelling compound to make sure that there

are no air bubbles beneath the heating mat. These

may lead to higher temperatures.

» Press the heating mat back down into the levelling

compound.

» Allow the levelling compound to cure in accordance

with manufacturer's instructions.

» Fill settlement joints with suitable materials, e.g.

silicone.

» Lay the oor covering in accordance with the manu-

facturer's instructions.

9.7 Test measurement 3

After laying the oor covering, check the total resistance

and insulation resistance of the heating mat to rule out

the possibility of damage to the heating mats.

Note

The warranty is not valid without proof of this meas-

urement.

» Measure the total resistance and insulation resist-

ance of the heating mats.

» Check whether the measured values are in the per-

missible measuring range (see chapter "Specica-

tion / Data table").

» Enter the measured values on the warranty card.

9.8 Power supply

WARNING Electrocution

Carry out all electrical connection and installation

work in accordance with relevant regulations.

Observe the local requirements of the relevant

power supply utility.

WARNING Electrocution

Only use a permanent connection to the power sup-

ply.

» Separate the appliance from the power supply

by an additional isolator that disconnects all

poles with at least 3 mm contact separation.

Use mains isolators, fuses, contactors, etc. for

this purpose.

» Install an RCD with a nominal earth leakage cur-

rent of ≦ 30 mA.

Material losses

The heating conductor must not be connected to

the power supply.

» Only connect the cold lead to the power supply.

Material losses

Observe the type plate. The specied voltage must

match the mains voltage.

Design all materials in accordance with the rated

consumption of the appliance.

Basic wiring diagram

(e.g. for temperature controller FRTD 903)

The basic wiring diagram below is provided for clarica-

tion purposes. The temperature controller wiring diagram

is the only applicable wiring diagram (see operating and

installation instructions for the temperature controller).

1 2 3 4 5 6

N L N L

t°

85_07_21_0002

1 2

1 Heating mat

2 Temperature sensor

In connection with the following installation steps, observe

the operating and installation instructions for the temper-

ature controller:

» Connect the earth conductor to the earth connection

(PE).

» Connect the heating mats to the temperature control-

ler via the cold lead.

» Check whether the earth conductor is connected

correctly.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of AEG TBS TB 50 THERMO BODEN in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 12,47 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

AEG TBS TB 50 THERMO BODEN Manual

Product: