654087

AEG SR 4367 BT Manual

46
Zoom out
Zoom in
Previous page
1/82
Next page
English
46
6 VOL / buttons
7 button
8 control lamp (Operating state)
9 control lamp (Bluetooth)
10 IR sensor for the remote control
11 Display
12 Rubber cover
The following connectors are under the cover:
SD memory card slot
USB port
AUX IN input
13 EQ button (Equalizer)
14 PLAY MODE button
15 FOLDER/PRE-UP button
16 MEM/CLK-ADJ button (Save/Setting the time)
A Passive membranes
Reverse (not shown)
DC 12V
mains socket (under the rubber cover)
Battery compartment
Remote control
1 FUNC button (function mode)
2 MO/ST button (Mono/Stereo)
3
button (playback/pause)
4 button (stop)
5 MEM/CLK-ADJ button (Storing/Setting the time)
6 INFO button (ID3 tag Meta data on/off)
7 SLEEP/TIMER button
8 EQ button (equalizer)
9 VOLUME / buttons (volume)
10 DISPLAY button
11 MUTE button (mute)
12 RAN/REP/INTRO button (playback mode)
13 FOLDER/PRESET / buttons (album/ respectively /
stored radio stations)
14 TUNING / button (radio station search downward/
previous track)
15 TUNING / button (radio station search upward/next
track)
16 I/ button (operational readiness)
Start-up of the device/Introduction
• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
• Sensitive surfaces, such as the display, might be protect-
ed with films. Remove such films.
Power supply (Adaptor)
1. Make sure the grid voltage corresponds to the figures on
the rating plate.
2. Connect the power adapter to a properly installed
grounded power outlet. Connect the device with the
plug connector by inserting its plug into the DC 12 V jack
of the device.
CAUTION:
• Only use the supplied power adaptor for this device.
Do not use for other devices.
• Only use power adaptor with 12 V (
), other
adaptors may cause damage to the device.
NOTE:
• Disconnect from mains power supply during longer
periods of non-use.
• The clock time/alarm settings will be lost, once discon
-
nected from the mains supply.
Battery operation (not supplied)
1. Open the battery compartment lid on the back.
2. Insert 8 batteries of type D/R20 1.5 V. Please ensure that
the polarity is correct (see the floor of the battery com-
partment)!
3. Then close the battery lid.
NOTE:
If a mains adapter is connected, the batteries will be dis
-
connected automatically.
CAUTION:
• Batteries may leak and lose battery acid. If the device
is not used for a longer period of time, remove the
batteries.
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer’s.
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like. Danger of explosion!
Remote control
NOTE:
The lithium cell in the battery compartment of the remote
control was secured with foil for transport. This extends the
battery life. Remove this foil before initial use to operate the
remote control.
For wireless operation from a distance of up to 5 meters.
During operation, please ensure a clear line of view between
the remote control and the sensor (10) on the device. If this
range should diminish, the battery must be replaced. Replace
the battery as follows:
… 46 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG SR 4367 BT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG SR 4367 BT in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 3,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info