464412

AEG SK 204 Manual

12
Zoom out
Zoom in
Previous page
1/36
Next page
12
For the User
1. Operating instructions
The installation and use of electrical appliances must be carried out with due caution in order to avoid the risk
of fire, electric shock or injury. The equipment must only be used as described in these instructions. Any use
outside of the manufacturer recommendations could lead to damage, fire, shock or injury.
Before using the appliance the instructions should be read in their entirety and all appropriate handling of the
equipment must be observed.
These instructions should be kept safely and passed on to any future owner.
In the event of any repair work, hand them to the qualified installer for his attention.
1.1 Unit description
The SK 204 (T) is suitable for heating rooms that are used infrequently, or to supplement an existing heating
system. These units can be used as mobile free-standing units with the feet fitted, or alternatively as wall han-
ging units.
The SK 204 (T) is supplied complete with a connecting cable.
Only remove the packaging of the unit and accessories at the place of installation, taking note of the additional
package.
When unpacking, take care to ensure that no accessories remain behind in the packaging material.
Unit design (see page 3)
1 Thermostat knob
2 Heat output switches
3 Air outlet grille
4 Fan air outlet grille (SK 204 T only)
5 Recessed grips
6 Foot
7 Hanging bracket
8 Unit rating label
Range of use
The use of the heater in bathrooms or similar damp environments is not permitted. The heater should not be
used outdoors.
The heat requirement of the room should be matched to the heat output of the unit. In very small rooms there is
a risk of overheating, damage and fire.
As a free standing appliance it can easily be used wherever heat is required (when used as a mobile free stan-
ding unit both feet must be fitted before switching on). The connection cable should not be covered with a
carpet or mat, and should lie outside any ‘traffic area’ where it could be caught and the heater overturned.
To prevent a tensed connecting cable (danger of stumble) do not position the appliance too distant from the
shockproof socket.
The use of an extension lead should be avoided. If an extension lead is used it should be of sufficient cable size
for the full rating power of the heater. It should have a moulded plug and socket and sufficient preventative
measures should be taken when using it.
The equipment should always stand on a solid floor, on soft ground the appliance can tilt or the air grilles
could be blocked.
When transporting the appliance it should be held only by the recessed grips provided for this purpose (5), un-
der no circumstances should it be carried by the mains electrical cable.
Function
To heat the air, ambient air entering the unit through the openings in the base of the unit is heated, this then
flows out by means of natural convection, via the air outlet grille (3) at the top.
In the case of the SK 204 (T), this process can be assisted by using the integral fan to push heat out through
the separate outlet grille (4).
1.2 Operation
The operating controls are located within the right hand side section of the unit.
Using the thermostat knob (1), the desired room temperature can be selected between approximately 5 °C and
35 °C.
The thermostat within the unit then keeps the ambient air constantly at this set value, by cycling the heating
on and off for short periods.
Using the switches (2), several different heat output levels can be selected (see following table). This gives in-
creased economy by adapting to the prevailing heat requirement.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG SK 204 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG SK 204 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info