563596
14
Zoom out
Zoom in
Previous page
1/64
Next page
14
Install auger control rod
The auger control rod (A) has the short loop on the end of the spring.
1. Slide rubber sleeve (B) up rod and hook end of spring into control arm
(C) with loop opening up as shown (D).
2. With top end of rod positioned under right side of control panel, push
down on rod and insert end of rod into hole in auger control bracket
(E). Secure with retainer spring (F).
Installation des Steuerhebels für die einzugssch-
necken
Die Feder an dem Steuerhebel für die Einzugsschnecken (A) ist mit einem
kurzen Haken am Ende versehen wie abgebildet.
1. Schieben Sie die Gummimanschette (B) auf den Hebel und verhaken
Sie das Federende mit dem Zwischenhebel (C), mit der Öffnung der
Schlaufe nach oben wie abgebildet (D).
2. Mit dem oberen Ende des Hebels rechts unter der Bedienungskonsole,
drücken Sie den Hebel nach unten und schieben Sie das obere Ende
des Hebels in das Loch in der Halterung für die Einzugsschnecken-
steuerung (E). Sichern Sie den Hebel mit der Halterungsfeder (F).
Installez la tige de contrôle de la vis sans fi n
La tige de contrôle de la vis sans fi n (A) a la boucle à la fi n du ressort.
1. Glissez le manchon de caoutchouc (B) le long de la tige vers le haut
et accrochez l’extrémité du ressort dans le bras de réglage (C) avec
la boucle ouvrant vers le haut tel qu’illustré (D).
2. Avec l’extrémité supérieure de la tige positionnée sous le côté droit du
panneau de contrôle, poussez vers le bas le long de la tige et insérez
l’extrémité de la tige à l’intérieur du trou dans le support de contrôle
de la vis sans fi n (E). Fixez avec le ressort de retenue (F).
Montar la biela de mando de la barrena
La biela de mando de la barrena (A) tiene un gancho corto al extremo del
resorte, como mostrado.
1. Deslizar el manguito de caucho (B) sobre la biela y enganchar la
terminación del resorte al brazo de control (C) con el gancho abierto
hacia arriba, como mostrado (D).
2. Con la extremidad superior debajo del lado derecho del panel de
control, empujar la biela hacia abajo e insertar el extremo de la biela
en el agujero del soporte del control de la barrena (E). Apretar con el
resorte de sujeción (F).
Het installeren van de regelstang van de boorre-
geling
De regelstang van de boorregeling (A) heeft een korte lus aan het eind
van de veer, zoals getoond.
1. Schuif de rubberen beschermhoes (B) om de regelstang en haak het
eind van de veer in de bedieningsarm (C) met de lusopening naar
boven, zoals getoond (D).
2. Als het boveneind van de regelstang gepositioneerd is onder de rech-
terzijde van het bedieningspaneel, druk de regelstang naar beneden
en bevestig het boveneind van de regelstang in het gat in de console
van boorregeling (E). Maak vast met de sluitveer (F).
Montaggio della barra di regolazione della coclea
La barra di regolazione della coclea (A) presenta un piccolo anello
all’estremità della molla come da illustrazione.
1. Fare scorrere il manicotto di gomma (B) lungo la barra ed agganciare
l’estremità della molla al braccio di controllo (C) con l’anello che si
apre verso l’alto come indicato (D).
2. Con l’estremità superiore della barra posta sotto il lato destro del pan-
nello di controllo, spingere verso il basso la molla e inserire l’estremità
della barra nell’apposito alloggiamento della staffa di controllo della
coclea (E). Assicurarla poi con una molla di fermo (F).
A
F
E
D
C
B
A
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG SB300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG SB300 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info