464371

AEG RTi 103 EP Manual

14
Zoom out
Zoom in
Previous page
1/36
Next page
14
For the Fitter
• Feed the 6-pole connector of the discharge control unit (A2 see circuit diagram) up along the
back of the angle plate into the slots "TA" to „N“ of the terminal block X2 from above and screw
(press cable harness into the existing cable straps).
• Plug and snap in the discharge control unit (6) in the elongated holes above the charging
control unit.
• Plug the connecting lead of the potentiometer into the slot X21 of the room temperature
regulator.
• Screw the room temperature sensor (7/B2) with 2 screws (2.9 x 6.5) to the front edge of the
floor plate. Plug the connecting cable to slot X20 of the room temperature regulator.
• Lay the enclosed separate wires along the back of the angle plate and connect according to the
following table (to the terminals X1 and X2 from below).
Designation
wire (black)
wire (brown)
of
L (X1)
LE’ (X2)
to
S2 (slot top)
S2 (slot bottom)
laying
Wires may not touch the control panel circuit board and singly insulated wires for safety low
voltage!
Tie the wires to the switch in the existing cable harness (cable straps can be opened and
reclosed).
• Swing back the angle plate and screw tight.
• Stick the control panel label to the outside of the right side wall.
• Fix the side wall, front wall and air outlet and inlet grille back to the unit
(in the right order!).
The toothed washers must be inserted under the fastening screws (protective earth connec-
tion!)
The connecting lead from the control panel to the room temperature regulator must be laid and
secured in the same way as the existing leads to the control panel. They may not touch the inter-
mediate wall and the heating element connections.
3
1
2
3
4
4
5
6
7
X1
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG RTi 103 EP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG RTi 103 EP in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info