473798
53
Zoom out
Zoom in
Previous page
1/132
Next page
Protect PV.500 Operating Instructions
80000031354 BAL 49 of 70
The X5 interface can be switched from RS485 to RS232 using
jumpers J4 and J5. The factory setting is RS485, i.e. all jumpers
are inserted at J4. You have the option of switching the interface to
RS232 by reconnecting all jumpers to J5.
Port 2 (X5): RS232 pin assignment
Pin number Signal Description
2 RxD PC receiving data
3 TxD PC sending data
5 GND Interface reference potential
7 RTS Handshake
8 CTS Handshake
Housing INV housing potential
If the RS232 version is used for this port, please use a 1:1 data
line.
Controller Area Network (CAN) at X4
You have the option of connecting up to four remote panels to the
potential-free CAN interface for central signalling and display.
1
Figure 16 Connector X4
Port 3 (X4): CAN pin assignment
Pin number Designation Cable colour coding
1 GND White + brown
2 Data_L Yellow
3 Data_H Green
Please use a shielded CAN bus cable as the line,
e.g. 2 x 0.22 twisted pair Lapp "UNITRONIC-BUS LD".
Route the CAN bus line from the PV inverter to the remote panel.
In a CAN bus network, the ends of the bus must always be
terminated. A 120 Ohm terminating resistor is pre-installed at
connector X4 of the CAN bus connection as standard.
Connect the line shield to the housing potential of the INV unit via
shield terminal blocks. Openings are provided in the plate of the
PV inverter for installing the shield in the connection room area.
Remove approx. 20 mm of the sheath at this point.
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG Protect PV 500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG Protect PV 500 in the language / languages: English as an attachment in your email.

The manual is 1,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of AEG Protect PV 500

AEG Protect PV 500 User Manual - German - 136 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info