558066
9
Zoom out
Zoom in
Previous page
1/44
Next page
MCC247
9
Installation
1. Remove any promotion label from the door.
2. The oven should be installed on a flat, level surface. The surface must be strong enough to
safely bear the weight (18 kg) of the oven, plus the contents. To avoid the possibility of
causing vibration or noise the oven must be in a stable position.
3. Keep the oven away from heat and water. Exposure to heat and water can lower oven
efficiency and lead to malfunctioning, so be sure to install the oven away from heat and
water sources.
4. Do not block air vents on the top and the sides of the cabinet and also do not place any
articles on the top of the oven. If air vents are blocked during operation, the oven may
overheat, and this may lead to malfunctioning. Hot air escapes from the vents, so be sure
not to obstruct it or let curtains come between the oven and the rear wall.
5. Place the oven as far away from radios and TV’s as possible. This oven does conform to EEC
requirements of radio interference suppression, but some interference may occur if it is
placed too close to a radio or TV, so keep them as far apart as possible.
6. If positioned in a corner, leave a gap of at least 5 cm from the walls and 5 cm above the
microwave.
ƽ MPORTANT! The oven can be placed almost anywhere in the kitchen. Make sure
the oven is placed on a flat, level surface and that vents as well as the surface
underneath the oven are not blocked (for sufficient ventilation).
Connecting to the mains
The oven is delivered with the power cord and a plug for 230–240 V, 50Hz, earthed socket outlet.
Earth protection minimises the risks should a short circuit occur. Check to ensure the voltage of
the oven matches the supply.
N.B. If the oven is connected to the socket via an extension cord, make sure the cord is earthed.
ƽ This appliance must not be used on a non-earth protected power supply.
Contact an electrician if you are uncertain regarding electrical connection of
the oven or provision of earth protection of the supply.
ƽ This appliance must be earthed. If this appliance is fitted with a non-
rewireable plug for which your socket is unsuitable, the plug should be cut off
and the appropriate plug fitted. If it is necessary to change the fuse in a non-
rewireable plug, the fuse cover must be refitted. If the fuse cover is lost or
damaged, the plug must not be used until a replacement is obtained.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG MCC247M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG MCC247M in the language / languages: English as an attachment in your email.

The manual is 0,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info