159792
40
Zoom out
Zoom in
Previous page
1/66
Next page
ENGLISH
ENGLISH
40
CD deck transport protection
Please open the CD compartment by pressing the OPEN/
CLOSE button (11).
Remove the transport protection from the CD player if
present before use.
Power supply
Insert the plug (27) into a properly installed 230 V, 50 Hz
power socket.
The POWER (1) control lamp shows the function.
Please ensure that the mains voltage corresponds to the
information on the type plate.
Inserting the Batteries (not supplied)
Open the lid of the battery compartment on the back of the
remote control.
Insert 2 batteries of type R03 „AAA“ 1.5 V. Please ensure
that the polarity is correct (see the fl oor of the battery
compartment or the inscription on the outside)!
If the remote control is not used for a prolonged period,
remove the batteries in order to prevent battery acid leaking.
Now close the battery compartment.
Different battery types or new and used batteries must not
be used together.
Warning: batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the relevant
collection bin or at your dealer’s.
Never throw batteries into the re.
General Operation
POWER/FUNCTION (5)
Switches the unit to „ready for operation“ or to „off“. The PO-
WER (1) control lamp shows the function.
Switch-off
The machine is turned off when the function selector switch (5)
is in the TAPE/OFF position and all tape functions are switched
off. The POWER (1) control lamp goes off. Unplug the device.
X-BASS ON/OFF (3)
To increase or decrease the bass output. The switch can be in
one of two positions
ON or OFF.
Volume
You can set the desired volume using the VOLUME control (7/8).
PHONES (4)
Insert the plug of a set of headphones into the headphone
socket – the loudspeakers are „muted“. If your headphone plug
does not fi t, please use a suitable adapter.
Loudspeakers
Connect the loudspeakers to the back of the music center to the
sockets market „Speaker R and L“ (26).
Infrared remote control
For operating the music centre from a distance of up to 5 metres
without a lead. If the range of the remote control is reduced, the
batteries have to be replaced. During operation ensure that there
is nothing blocking the direct line between the remote control
and the sensor (2) on the machine.
Listening to the Radio
1. Turn the function selector switch (5) to the TUNER position.
2. Select the desired frequency band with the band selection
switch (6).
Medium wave = AM (mono); VHF = FM; VHF = FM ST.
3. Tune in the desired station with the station adjustment knob
TUNING (10).
4. The control lamp (in the display) (9) only lights up
when you have selected FM stereo and the station is being
received in stereo quality. If reception is too weak and there
is noise on the station being received, this lamp will fl icker.
Try to improve reception by turning and bending or twisting
and altering the length of the antenna (25).
5. An aerial is integrated into the device for the reception of
AM stations. The machine can be aligned to the station by
turning it. In this frequency band programs are transmitted in
„mono“ only.
Cassette Operation
Playing Cassettes
1. Select the function OFF/TAPE (5).
2. Open the ap (18).
3. Press the
˾
/
̆
Stop/Eject button (20) in order to open the
cassette compartment (17).
4. Push a recorded audio cassette, with the OFF/TAPE
downwards and the listening side facing forwards, into the
compartment. Close the cassette compartment.
5. Press the
̈
playback key (23) to listen to the OFF/TAPE.
6. With the
˾
/
̆
stop/eject key (20) you can stop playback.
7. Wind the OFF/TAPE forwards or backwards if necessary in
the direction of the arrow keys.
̈̈
= forwards (21),
̇̇
= reverse (22).
Always press the
˾
/
̆
stop/eject key (20) when changing
the direction or stopping the OFF/TAPE. This prevents
damage to the machine and the OFF/TAPE.
8. If the
˾
/
̆
stop/eject button (20) is pressed again the fl ap
of the cassette compartment opens.
9. In order to interrupt playback briefl y, press the II pause
button (19). Pressing again continues playback.
Recording Cassettes
1. Insert an audiocassette with the side on which you wish to
record facing forwards. Ensure that the cassette is not copy-
protected (the copy protection tab on the top narrow side of
the cassette must not have been removed).
05-MC 4408 CD AEG 40 15.08.2006, 8:58:11 Uhr
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG mc 4408 cd mp3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG mc 4408 cd mp3 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info