794399
45
Zoom out
Zoom in
Previous page
1/52
Next page
Problem Possible solution
You cannot open the
appliance door.
Make sure that a washing programme that ends with water in
tub, has not been selected.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the
drum.
Make sure that the appliance receives electrical power.
This problem may be caused by a failure of the appliance.
Contact the Authorised Service Centre.
If you need to open the door, please read carefully "Emergen‐
cy door opening".
The appliance makes
an unusual noise and
vibrates.
Make sure the levelling of the appliance is correct. Refer to
"Installation instruction".
Make sure that the packaging and/or the transit bolts are re‐
moved. Refer to "Installation instruction".
Add more laundry in the drum. The load may be too small.
The programme dura‐
tion increases or de‐
creases during pro‐
gramme execution.
The ProSense System is able to adjust the programme dura‐
tion according to the type and the laundry load size. Refer to
"The ProSense System load detection" in "Daily Use" chapter.
The washing results
are not satisfactory.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before
you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Make sure that no other type of detergent has been poured
the compartment
Salt
. In this case, refer to "Eliminating deter‐
gent or other additives from salt compartment'.
Make sure that no salt has been poured in the compartment
. If it happens, run a rinse cycle or run the washing cycle
again.
Too much foam in the
drum during the wash‐
ing cycle.
Reduce the quantity of detergent or the number of tablets or
single-dose detergents.
Excessive consump‐
tion of salt.
Check if the water softener has been set to act also during
rinse phase. Refer to "How to set the water hardness level" in
"The Water Softener (Soft Water)" chapter.
Salt is not consumed.
The appliance may need a water softener regeneration: run a
a Cottons or a Synthetics cycle. Refer to "Water softener re‐
generation" in "The Water Softener (Soft Water)" chapter.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
ENGLISH 45
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG LR9586BN4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG LR9586BN4 in the language / languages: English as an attachment in your email.

The manual is 1.46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of AEG LR9586BN4

AEG LR9586BN4 User Manual - German - 60 pages

AEG LR9586BN4 User Manual - Dutch - 56 pages

AEG LR9586BN4 User Manual - French - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info