566609
82
Zoom out
Zoom in
Previous page
1/88
Next page
Machine settings
Setting Implementation
Buzzer permanent
on/off
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE (DELICAAT) and BUZZER (ZOEMER)
buttons and hold down for approx. 5 seconds.
diode above BUZZER (ZOEMER) button starts lighting - buzzer per-
manently on.
lighting diode comes off - buzzer permanently off.
3. The buzzer is by default always off. You can use the BUZZER (ZOEMER)
button to activate or deactivate sound but the machine does not
memorize your selection.
Water hardness
1)
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE (DELICAAT) and START PAUSE
(START PAUZE) buttons and hold down for approx. 5 seconds. The
current setting is shown by the following red diodes:
WATER RESERVOIR (TANK) diode on - high conductivity >600 μS/
cm
FILTERS (ZEEF) diode on - medium conductivity 300-600 μS/cm
CONDENSER (WARMTEWISSELAAR) diode on - low conductivity
<300 μS/cm
3. Press the START PAUSE (START PAUZE) button sequentially until you
set desired level.
4. To memorize setting press simultaneously the DELICATE (DELICAAT)
and START PAUSE (START PAUZE) buttons or turn knob to OFF (UIT)
position
Emptying water res-
ervoir - warning LED
off
2)
1. Turn the programme selector to any programme.
2. Press simultaneously the BUZZER (ZOEMER) and DELAY START (STAR-
TUITSTEL) buttons and hold down for approx. 5 seconds.
The current setting is shown by the following red diode:
WATER RESERVOIR (TANK) diode flashes - diode warning is per-
manently off
WATER RESERVOIR (TANK) diode steady - diode warning is activa-
ted
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the
end of the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity
values of the water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water reservoir
is full. When using an external drain for the condensed water warning can be off
Technical data
82
Machine settings
82


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG LAVATHERM 55840 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG LAVATHERM 55840 in the language / languages: French as an attachment in your email.

The manual is 8,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of AEG LAVATHERM 55840

AEG LAVATHERM 55840 User Manual - German - 44 pages

AEG LAVATHERM 55840 User Manual - Dutch - 44 pages

AEG LAVATHERM 55840 User Manual - Dutch - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info