775194
54
Zoom out
Zoom in
Previous page
1/64
Next page
Problem Possible solution
The washing results
are not satisfactory.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before
you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
When using AutoDose tanks, make sure that they are not
empty.
When using AutoDose tanks, verify the pre-set detergent/
fabric softener dosage. Refer to "Basic setting" paragraph in
"The AutoDose Technology" chapter.
Make sure that you have cleaned the AutoDose tanks before
using different brand and type of detergent, fabric softener or
other additives.
Too much foam in the
drum during the wash‐
ing cycle.
Reduce the quantity of detergent.
When using AutoDose tanks, verify the pre-set detergent/
fabric softener dosage. Refer to "Basic setting" paragraph in
"The AutoDose Technology" chapter.
The detergent/fabric
softener level does not
decrease in the Auto‐
Dose tanks after wash‐
ing.
This is normal: tanks are quite large and detergent consump‐
tion may be not so evident.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
15.2 Emergency door
opening
In case of power failure or functioning
failure the appliance door remains
locked. The washing programme
continues when the power is restored. If
the door remains locked in case of
failure, it is possible to open it using the
emergency unlock function.
Before opening the door:
CAUTION!
Risk of burns! Make sure
that the water temperature
is not too high and the
laundry is not hot. If
necessary, wait until they
cool down.
CAUTION!
Risk of injury! Make sure
that the drum is not
rotating. If necessary, wait
until the drum stops
rotating.
Make sure that the water
level inside the drum is
not too high. If necessary,
proceed with an
emergency drain (refer to
«Emergency drain» in
«Care and cleaning»
chapter).
To open the door, proceed as follows:
1. Press the Aan Uit/Marche Arrêt
button to switch the appliance off.
2. Disconnect the mains plug from the
mains socket.
3. Open the filter flap.
www.aeg.com54
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG L7FEQ96ES at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG L7FEQ96ES in the language / languages: English as an attachment in your email.

The manual is 1.59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of AEG L7FEQ96ES

AEG L7FEQ96ES User Manual - German - 68 pages

AEG L7FEQ96ES User Manual - Dutch - 68 pages

AEG L7FEQ96ES User Manual - French - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info