697621

AEG KAM400 Manual

11
Zoom out
Zoom in
Previous page
1/46
Next page
11www.aeg.com
GB
DE
ES
FR
GR
NL
PT
TROUBLESHOOTING
PROBLEM SOLUTION
The appliance does not work. Put the mains plug in the wall socket..
Make sure that the voltage indicated on the appliance corresponds to the local
mains voltage.
Fill the water reservoir with water.
When I use the grinder, the coee is too weak. Make sure the number of cups you select with the 2-10 cups button is
consistent with the amount of water in the water reservoir. Please keep in
mind that the appliance uses all the water in the water reservoir.
Use the STRENGTH button to set the coee strength to ‘strong’.
When you use coee beans, make sure you do not press the preground coee
button, as this switches o the grinder.
Use coee beans of a stronger blend or avour.
To increase the coee strength, select a higher number of cups with the 2-10
cups button than the number of cups you ll the water reservoir with.
When I use pre-ground coee, the coee is
too weak.
Make sure the amount of pre-ground coee in the lter is consistent with the
amount of water in the water reservoir. Please keep in mind that the appliance
uses all the water in the water reservoir.
Use ground coee of a stronger blend or avour.
To increase the coee strength, increase the amount of pre-ground coee or
decrease the amount of water.
I have set the coee strength to ‘strong’ with
the STRENGTH button, but the coee is too
weak.
When the grinder is switched o, you cannot change the coee strength with
the STRENGTH button. In this case you can only increase the coee strength
by increasing the amount of pre-ground coee or decreasing the amount of
water, or by using coee of a stronger blend or avour.
The lter overows when I remove the jug
from the appliance while it is brewing coee.
If you remove the jug for more than 20 seconds during the brewing process,
the drip stop causes the lter holder to overow. Also note that the coee
does not reach its full taste before the end of the brewing process. Therefore
we advise you not to remove the jug and pour out the coee before the end of
the brewing process.
The appliance continues to drip long after the
brewing mprocess has ended.
The dripping is caused by condensation of steam. It is completely normal that
the appliance drips for some time.
If the dripping does not stop, the drip stop may be clogged. To clean the drip
stop, push it to open it and then rinse it under the tap.
If you remove the jug for more than 20 seconds during the brewing process,
the drip stop causes the lter basket to overow.
The coee is not hot enough. Place the jug properly on the hotplate.
Make sure that the hotplate and the bottom of the jug are clean.
Use thin cups, because they absorb less heat from the coee than
thick cups.
Do not use milk that comes directly out of the fridge.
Descale the appliance. See section ‘Descaling’ in chapter ‘Cleaning and
maintenance’.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG KAM400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG KAM400 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 9,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info