Manual AEG IR Comfort 2024 (page 12 of 36) (English, German, Dutch, French)

648405

Zoom out

Zoom in

1/36

Operation – for users and qualied contractors

CAUTION Burns

Observe the minimum clearances (see chapter

"Specication").

Never place any objects on top of the appliance.

Never lean any objects against it or place any ob-

jects between the appliance and the wall.

Never place any ammable, combustible or insulat-

ing objects or materials, such as laundry, blankets,

magazines, containers with oor polish or naphtha,

spray cans or similar, near the appliance.

CAUTION Burns

◦ Parts of the appliance can get very hot and may

cause burns. Particular caution is advised when

children or vulnerable persons are present.

◦ The grille also remains hot after the appliance is

switched off.

◦ Never touch the quartz tubes.

◦ Never adjust the pivoting angle of the appliance

in use.

Material losses

◦ Ensure that the power cable is never in contact

with the hot appliance, other parts or sharp

edges.

◦ The power cable may only be replaced (for ex-

ample if damaged) by a qualied contractor au-

thorised by the manufacturer, using an original

spare part.

Never cover the appliance.

2.3 Test symbols

See type plate. The type plate is located at the back of

the appliance.

3. Appliance description

The appliance only warms the air slightly. It is only when

it hits objects or the human body that the IR radiation is

converted into heat. You will feel the heat after just a few

seconds.

The radiant heater body is made from aluminium. The

protective grille and screws are made from stainless steel.

4. Operation

4.1 Starting the appliance without

Hirschmann plug-in connection

» Start the appliance by pushing the power plug into its

socket.

4.2 Switching the appliance on with

Hirschmann plug-in connection

» If not already in place, connect the power cable to

the cable with mains plug.

» Start the appliance by pushing the power plug into its

socket.

4.3 Switching OFF the appliance

» Switch off the appliance by pulling the power plug

from its socket.

5. Cleaning, care and

maintenance

Note

◦ Never spray the appliance with water. Never im-

merse the appliance in water.

◦ Never touch the quartz rods with your ngers,

otherwise spots can form or the quartz rods

might be destroyed.

» Isolate the appliance from the power supply and let it

cool down.

» A damp cloth is sufcient for cleaning the casing.

Never use abrasive or solvent-based cleaning

agents. Go over with a soft cloth.

» Regularly clean the reector through the grille using

a paint brush.

Let a contractor clean the reector if it

is heavily soiled to retain the full level of heat radia-

tion of this appliance.

The heating tube (gold tube) has a maximum service life

of approx. 5000 hours. It is subject to the operating con-

ditions, such as the relative humidity, switching frequency

and the orientation of the radiant heater.

6. What to do if...

6.1 ... you notice a smell

◦ For a short time after rst taking the appliance into

use as well as after longer breaks in use, a smell

may develop.

6.2 ... the appliance does not radiate any

heat

◦ Check whether the fuses/MCBs have blown/tripped

or are faulty.

If you cannot remedy the fault, notify your qualied con-

tractor. To facilitate and speed up your request, provide

the number from the type plate (000000-0000-000000).

INSTALLATION

7. Safety

Only a qualied contractor should carry out installation,

commissioning, maintenance and repair of the appliance.

7.1 General safety instructions

We guarantee trouble-free function and operational relia-

bility only if original accessories and spare parts intended

for the appliance are used.

7.2 Instructions, standards and regulations

Note

Observe all applicable national and regional regula-

tions and instructions.

Note

When installing the appliance in rooms with a bath

and/or shower, observe the safety zone in accord-

ance with the details on the type plate.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of AEG IR Comfort 2024 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,67 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

AEG IR Comfort 2024 Manual

Product: