Manual AEG IDE74243IB (page 8 of 168) (English, German, Dutch, Danish, French, Italian, Swedish, Norwegian, Finnish)

780558

Zoom out

Zoom in

1/168

non-electrical energy, the negative

pressure of the room must not exceed 4

Pa (4 x 10●5 bar). This manual must be

stored for future consultation at any time.

If sold, transferred or moved, it must

remain with the device.

Caution! Failure to install screws and

fasteners in accordance with these

instructions may result in electrical

hazards.

● Both electric and mechanical

installation must be carried out by

specialised personnel.

The electrical appliance is designed to be

built into a work top with a thickness of 2-

6 cm in the case of TOP installation; 2.5-

6 cm in the case of FLUSH installation.

The minimum distance between the hob

and the wall must be at least 5 cm in

front, at least 4 cm on the sides and at

least 50 cm from overhead wall units.

NB = The recommended distances are

given as examples: when planning the

spaces, the indications of the kitchen

manufacturer must be observed.

Electrical connection:

● Disconnect the device from the electric

power supply. ● Installation must be

carried out by professionally qualified

personnel with knowledge of the

regulations in force for installation and

safety. ● The manufacturer denies all

liability to persons, animals or property if

the guidelines provided in this chapter

are not followed. ● The power cable

must be long enough to allow the hob to

be removed from the worktop. ● Make

sure that the voltage on the serial

number data plate on the bottom of the

device corresponds to that of the

domestic environment where it will be

installed. ● Do not use extension leads.

● The earth power cable must be 2cm

longer than the other cables. ● If the

electrical appliance is not supplied with a

power cable, use one with a minimum

conductor diameter of 2.5 mm2 for power

up to 7200 Watt; for higher power levels,

the diameter must be 4 mm2. ● The

temperature must not reach 50°C above

room temperature anywhere along the

cable. ● The appliance is intended for

permanent connection to the power

supply.

● Please note! Before reconnecting the

circuit to the mains power supply, make

sure that it is working correctly, always

check that the power cable is correctly

installed. ● Please note! The

interconnection cable must be replaced

by the authorised technical support

service or by a person with similar

qualifications.

Note: to connect the appliance using the

optional single phase connection the

existing cable must be removed and

replaced with another type (not supplied)

having the following specifications:

single phase connection:H05V2V2-F 3G4

cable

Note : the product is equipped with a

Power Limitator function, which allows a

maximum power limit to be set

The limit must be set at the time of the

product's connection to the electrical

network or when the electrical network

itself is reconnected (within the following

2 minutes). For the Power Limitation

setting sequence, see the Operation

section of this manual.

This device is marked in compliance with the European

Directive 2012/19/EC - UK SI 2013 No3113, Waste Electrical

and Electronic Equipment (WEEE). By ensuring that this

device is disposed of correctly, the user will help prevent

potential negative impacts on the environment and human

health.

The symbol on the device or documentation provided

indicates that this device must not be treated as domestic

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of AEG IDE74243IB in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 11.02 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

AEG IDE74243IB Manual

Product: