42
The freezer temperature is not
sufficient, red light lights up,
temperature signal sounds
The appliance is near a heat
source.
Temperature is not properly
adjusted.
Please look in the "Initial Start
Up" section.
Press the fast freeze switch
Door was open for an exten-
ded period.
Please look in the "Installation
location" section.
Disturbance on the appliance
Switch on the fast freeze
switch, keep the freezer clo-
sed, inform your customer
service
A large quantity of warm
food was placed in the
appliance within the last 24
hours.
Open the door only as long as
necessary.. Press the fast free-
ze switch
Malfunction Possible Cause
Remedy
Heavy build up of frost, possi-
bly also on the door seal.
Door seal is not air tight (pos-
sibly after changing over the
hinges).
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand such that it sits
correctly.
Unusual noises.
The appliance is touching the
wall or other objects.
Appliance is not level.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
The compressor starts after a
period of time.
This is normal, no error has
occurred.
The compressor does not start
immediately after changing
the temperature setting.
If necessary, carefully bend
the component out of the
way.
Move the appliance slightly.
Readjust the feet.
Close the door and re-open it,
the light will function auto-
matically again.
This is normal, no error has
occurred.
If the door remains open for
more than 7 min., the light
will be switched off by the
electronics.
