367284
28
Zoom out
Zoom in
Previous page
1/164
Next page
26
Installation
If fitting the microwave in position B or C:
The cupboard must be a minimum of
500mm (E) above the worktop & must not
be installed directly above a hob.
This appliance has been tested and
approved for use near domestic gas,
electric and induction hobs only.
Sufficient space between hob and
microwave should be allowed to prevent
overheating of microwave oven,
surrounding cupboard and accessories.
Do not operate the hob without pans
when the microwave oven is operating.
Care should be taken when attending to
the microwave oven while the hob is on.
SAFE USE OF THE APPLIANCE
INSTALLING THE APPLIANCE
1. Remove all packaging and check carefully for any
signs of damage.
2. This oven is designed to fit into a 360mm high
cupboard as standard.
When fitting into a 350mm high cupboard:-
Unscrew and remove the 4 feet from the bottom of
the oven. There are 3 tall feet and 1 short foot.
Replace the 3 tall feet with those provided in the
accessory pack. Do not replace the short foot.
3. If fitting the microwave oven above a conventional
oven (position A) then use the mylar sheet provided.
a. Cut the Mylar sheet to
fit the internal
width of the
unit.
b. Peel back the
protective
cover on the
tape and fix
to the rear of
the shelf so
that it covers
the service gap.
(See diagram).
4. Fit the appliance into the kitchen cupboard slowly,
and without force, until the front frame of the oven
seals against the front opening of the cupboard.
5. Ensure the appliance is
stable and not leaning.
Ensure that a 5mm gap is
kept between the cupboard
door above and the top of
the frame (see diagram).
6. Fix the oven in position with the
screws provided.
The fixing points are located on
the top and bottom corners of
the oven (see diagram, item 9,
on page 4).
7. It is important to ensure that the installation of this
product conforms to the instructions in this
operation manual and the hob or conventional oven
manufacturer’s installation instructions.
5 mm
E
D
Mylar sheet
Position A
Position B
Position C
Position D
Conventional
oven
Conventional
oven
Internal width
Service gap
POSITION NICHE SIZE CHIMNEY Gap Between
W D H (min) Cupboard & Ceiling
A 560 x 550 x 360 50 50
B + C 460 x 300 x 350 15 50
460 x 300 x 360 15 50
560 x 300 x 350 15 50
560 x 300 x 360 15 50
D 460 x 500 x 350 40 50
460 x 500 x 360 40 50
560 x 500 x 350 40 50
560 x 500 x 360 40 50
Measurements in (mm)
Chimney
Chimney
1. AG-21+22D-EU English 22/11/2005 15:34 Page 26
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aeg-electrolux mc 1761 e a micromat at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aeg-electrolux mc 1761 e a micromat in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info