361354

Aeg-electrolux cp 2200 Manual

36
Zoom out
Zoom in
Previous page
1/132
Next page
g
36
6 Making Ready-ground
Coffee
This function allows you to brew pre-
ground coffee, e.g. decaffinated cof-
fee.
Note that you must use only the sup-
plied measuring spoon, and never put
more than 2 level measuring spoons of
ground coffee into the ground coffee
filler.
1
Note! Make sure that no ground coffee
has remained in the filler, and that no
foreign bodies enter the filler. The
ground coffee filler is not a storage
container. The ground coffee must be
fed directly into the coffee-making
unit.
1
Do not put any water-soluble or
freeze-dried instant powders or any
other drink powder into the ground
coffee filler. Coffee powder, which is
too fine, can lead to blockages.
6.1 Using the Ground Coffee Filler
0 Turn the coffee bean container to the
"Ground Coffee" position (Fig. 14).
The mechanism sets to the required
function.
3
When using ready ground coffee, the
"Coffee Quantity" function is inactive.
All coffee quantity indicator lamps
(Fig. 3, c) are extinguished (Fig. 15).
0 Open the lid of the ground coffee filler,
and spoon in the fresh ground coffee
(Fig. 16).
Do not add coffee during the brewing
process. Only put in ground coffee for
the next cup when the brewing process
has completely finished and the coffee
machine is ready.
0 Close the lid.
6.2 Select Cup Size
Refer to „Select Cup Size" page 35.
6.3 Dispensing Coffee
Refer to „Dispensing Coffee" page 35.
7 Frothing Milk
The steam can be used to froth milk
and to heat liquids. Since a higher
temperature is needed to produce
steam than to make coffee, the coffee
machine has an additional steam
mode.
3
To make a cappuccino, fill a large cup
1/2 to 2/3 full with espresso, and then
add the frothed milk.
1
Caution! Danger of scalding when the
steam nozzle is activated! Hot water or
steam output can cause scalding. Do
not activate the steam nozzle until it is
immersed in the milk.
0 To produce steam, press the "Steam
Pre-selector" key (Fig. 3, g) . The
indicator illuminates, at the same time
the "Coffee machine heating" indica-
tor (Fig. 3, i) flashes. When the heat-
ing process is finished, this indicator
changes from flashing to constantly
on. The coffee machine is now ready
for frothing milk.
3
If the steam function is left unused for
more than 1 minute, the coffee
machine automatically changes back
to coffee-making mode.
3
To avoid any residual water mixing in
with the milk when frothing, the water
should be drained off beforehand. To
do this, place a container under the
steam nozzle and turn the selection
dial for steam and hot water (Fig. 1, d)
to position until steam emission
stops. Then turn the selection dial back
to position .
0 Pour low-fat, cold milk into a mug
which must be small enough to fit
under the steam nozzle.
3
The milk should be cold. You should
also use a cold mug, preferably a stain-
less steel one which should not be
rinsed beforehand in hot water.
0 Swing out the steam nozzle and hold
the mug under the steam nozzle so
that the nozzzle opening is just
immersed in the milk.
822_949_318 CP2..._defnep.book Seite 36 Freitag, 2. November 2007 6:30 18
… 36 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aeg-electrolux cp 2200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aeg-electrolux cp 2200 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 6,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info