361354
33
Zoom out
Zoom in
Previous page
1/132
Next page
g
33
4 Using for the First Time
4.1 Setting Up and Connecting the
Coffee Machine
Place machine on a suitable horizontal,
stable, unheated, dry and water-resist-
ant surface. Ensure good air circula-
tion.
Important! If the coffee machine is
brought into a warm room from a cold
environment, wait about two hours
before switching on!
We advise you to place the coffee
machine on a suitable mat to prevent
damage being caused by spray and
splashes.
0 Hold the bean container with the
marking on the "Unlock container"
position, and set it in place (Fig. 4).
The bottom opening of the bean con-
tainer must be closed (Fig. 4,a). If it is
not closed (Fig. 4,b), insert the tip of a
ballpoint pen in the small oval hole
(arrow) of the black ring with the
marking "TOP“ and turn opening clock-
wise as far as the stop.
0 Now turn the bean container anti-
clockwise to the position "Coffee
beans“ (Fig. 10) or further on to
the position "Powder“ (Fig. 14).
0 Push the drip tray in, until it engages
on the right under the water tank
(Fig. 5).
0 Plug the coffee machine into an
earthed mains socket. Do not use a
socket that is not earthed!
0 If you do not need the full length of
the mains lead, open the cable com-
partment on the back of the coffee
machine, and tidy away the unused
lead (Fig. 6).
4.2 Filling with Water
Each time before switching on the cof-
fee machine, check that there is water
in the water tank and refill if necessary.
The coffee machine requires water for
the automatic rinsing processes each
time the machine is switched on or off.
0 Remove the water tank from the cof-
fee machine (Fig. 7).
0 Fill the water tank with fresh cold
water (Fig. 8).
3
Pour only fresh cold water in the water
tank. Never put in other liquids, e.g.
mineral water or milk.
0 Replace the water tank (Fig. 7). Press
the tank firmly in, to ensure that the
water-tank valve opens.
3
If water must be refilled during the use
of the coffee machine, the "Fill water
tank" indicator (Fig. 3, k) flashes.
Coffee resp. hot water/steam prepara-
tion is interrupted. Fill the water tank!.
3
To always be sure of a rich coffee, full
of aroma, you should:
change the water in the water tank
daily
wash the water tank at least once per
week in normal washing-up water (not
in the dishwasher). Then flush with
fresh water.
4.3 Switching the Coffee Machine
On
0 Switch the coffee machine on by
means of the "On/Off" key (Fig. 3, h)
(Fig. 9). The red indicator light
comes on. While the water is being
heated (approx. 60 seconds) the "Cof-
fee machine heating" indicator (Fig. 3,
i) flashes.
0 Once the operating temperature has
been reached, the coffee machine car-
ries out an automatic flushing cycle.
The water flows out into the drip tray.
The "Coffee machine heating" indica-
tor (Fig. 3, i) remains constantly on.
The coffee machine is now ready to
use.
3
Immediately after being switched on
the coffee machine runs through a set-
up cycle. The noises this creates are
completely normal.
822_949_318 CP2..._defnep.book Seite 33 Freitag, 2. November 2007 6:30 18
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aeg-electrolux cp 2200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aeg-electrolux cp 2200 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 6,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info