361847

Aeg-electrolux cf 260 Manual

34
Zoom out
Zoom in
Previous page
1/100
Next page
g
34
4.2 Selecting the Cup Measure
0 Repeatedly press the "Cup Measure"
key (Fig. 3, d) until the desired cup
symbol is indicated.
The cup measures are indicated as fol-
lows:
Espresso cup
Coffee cup
Coffee mug
The coffee machine is factory-set to
standard measures.
3
Notes on changing the cup measures
can be found in „Changing and Saving
the Cup Measure" Page 35.
4.3 Dispensing Coffee
Refer to „Dispensing Coffee" Page 33.
5 Frothing Milk
The steam can be used to froth milk
and to heat liquids. Since a higher
temperature is needed to produce
steam than to make coffee, the coffee
machine has an additional steam
mode.
3
To make a cappuccino, fill a large cup
1/2 to 2/3 full with espresso, and then
add the frothed milk.
1
Caution! Danger of scalding when the
steam nozzle is activated! Hot water or
steam output can cause scalding. Do
not activate the steam nozzle until it is
immersed in the milk.
0 To produce steam, press the "Steam
Pre-selector" key (Fig. 3, g) . The
indicator illuminates, and at the same
time, the "Coffee machine heating"
indicator (Fig. 3, i) flashes. When the
heating process is finished, this indica-
tor changes from flashing to con-
stantly on. The coffee machine is now
ready for frothing milk.
3
If the steam function is left unused for
more than 1 minute, the coffee
machine automatically changes back
to coffee-making mode.
0 Pour approximately 100 ml cold,
skimmed or semi-skimmed milk into a
small, narrow jug (max. 0.5 l capacity).
This must be small enough to fit under
the steam nozzle.
3
The milk should be cold. You should
also use a cold jug, and not rinse this
with hot water.
0 Swivel the steam nozzle out and hold
the jug under the steam nozzle so that
the end is completely immersed in the
milk. Turn the Selection dial for steam
and hot water (Fig. 1, D) to the
position (Fig. 17). The milk is now
frothed up.
3
Hold the jug steady duing the frothing
process. The nozzle should not be
allowed to touch the bottom of the
jug, since this would prevent the steam
escaping. Froth the milk until the vol-
ume has at least doubled.
0 To stop frothing, turn the Selection dial
for steam and hot water (Fig. 1, D) to
the position and remove the jug
(Fig. 17).
1
Caution! Danger of scalding from hot
milk spray! Switch the steam off,
before removing the jug with the
frothed milk.
0 To finish steam mode, press the "Steam
Pre-selector" key (Fig. 3, g) . The
indicator goes out.
The coffee machine is now ready for
making coffee again.
0 Each time you have frothed milk, let
off some hot water through the nozzle
for a short time by setting the Selec-
tion dial for steam and hot water (Fig.
1, D) to the position. This is nec-
essary to prevent milk residues drying
inside the nozzle, and thereby blocking
it. Use a suitable container to catch the
water.
0 Remove the frothing aid after each use
(Fig. 18) and flush the milk residues
away under running water. Wipe the
steam nozzle off with a damp cloth.
… 34 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aeg-electrolux cf 260 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aeg-electrolux cf 260 in the language / languages: English, German, Dutch, Portuguese, Spanish as an attachment in your email.

The manual is 4,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info